Pioneer Cables 614927 Engine Mount - Front

Pioneer Cables 614927 Front Engine Mount

Pioneer Cables 614927 is a specific-fit hydraulic front engine mount for select Volkswagen applications. Built with aluminum and rubber construction, it is made to match OE-style mounting geometry and support the engine at the front position.

• Hydraulic engine mount for controlled vibration isolation
• Aluminum and rubber construction
• Front mounting position
• Specific fit for direct application matching
• Meets or exceeds original equipment manufacturer requirements
• Mounting hole quantity: 7
• No heat shield included
• No mounting hardware included

Vehicle Fitment

• Fits 2018-2019 Volkswagen Passat, front. Complete assembly.
• Fits 2012-2014 Volkswagen Beetle, front.
• Fits 2006-2010 Volkswagen Beetle, front.
• Fits 2010-2014 Volkswagen Golf, front.
• Fits 2005-2014 Volkswagen Jetta, front.
• Fits 2012-2014 Volkswagen Passat, front.

This part cross-references 1J0199262CR and C4927 for the same application. The 614927 engine mount is a direct-fit option for Volkswagen Passat, Volkswagen Jetta, Volkswagen Golf, and Volkswagen Beetle models listed above, making it a practical replacement when the original front mount is worn or damaged.

Common Replacement Reasons

• Excessive engine vibration felt in the cabin
• Clunking or shifting during acceleration and deceleration
• Visible cracking, separation, or fluid loss from the mount
• Engine movement caused by a failed front mount
• Noise transfer from a deteriorated hydraulic mount

Installation Notes

Verify the front mounting position and match the vehicle application before installation. Inspect surrounding brackets and fasteners for wear, and confirm the 7-hole mounting pattern aligns with the original assembly. Because mounting hardware is not included, reuse or replace fasteners as needed according to service procedures.

Quality Assurance

Pioneer Cables 614927 is built to meet or exceed original equipment manufacturer specifications for the listed applications. Its hydraulic design and OE-style material selection support consistent fitment on compatible Volkswagen front engine mount applications.