Pioneer Cables TAT-5320 Clutch Alignment Tool

Pioneer Cables TAT-5320 Clutch Alignment Tool

The Pioneer Cables TAT-5320 clutch alignment tool is built for clutch service work that requires accurate centering of the disc during installation. With a 10-spline design and a 0.594-inch input shaft diameter, it matches the shaft and hub dimensions needed for specific manual transmission applications.

Key Features

• 10-spline clutch alignment tool for precise disc centering
• 0.594-inch input shaft diameter for proper shaft engagement
• Helps align the clutch disc to the transmission input shaft during service
• Useful for manual transmission clutch replacement and reassembly
• Pioneer Cables part number TAT-5320 for easy identification

Detailed Description

Pioneer Cables TAT-5320 is a clutch alignment tool intended for manual transmission clutch installation where the spline count and input shaft diameter must match the vehicle’s clutch and transmission interface. The 10-spline configuration and 0.594-inch shaft diameter are the key specifications to verify before ordering, especially when searching for a clutch alignment tool for 10 spline 0.594 input shaft applications. For buyers comparing Pioneer Cables TAT-5320 against other service tools, these dimensions are the primary fitment identifiers.

Use this tool when servicing vehicles that require accurate clutch disc centering for proper transmission installation. It is relevant for manual transmission work on applications such as Honda Civic and similar make/model searches where the clutch hub and input shaft dimensions must be matched correctly. If you are looking for a Pioneer Cables TAT-5320 clutch alignment tool for Honda Civic manual transmission service, confirm the spline count and shaft diameter against the vehicle’s clutch assembly before use.

What It Helps Address

• Misaligned clutch disc during installation
• Difficulty sliding the transmission into place
• Incorrect centering of the clutch hub on the input shaft
• Repeated removal and reinstallation during clutch service
• Fitment uncertainty when selecting a 10-spline clutch alignment tool

Installation Notes and Tips

Verify the clutch hub spline count and input shaft diameter before installation. Match the tool to the transmission input shaft and use it to center the clutch disc before tightening the pressure plate. For best results, compare the dimensions on the clutch assembly and transmission components first, especially on Honda Civic manual transmission applications and other vehicles that use the same 10-spline, 0.594-inch specification. Part number TAT-5320 should be checked against the service application before purchase.

Quality Assurance

Pioneer Cables identifies this tool by part number TAT-5320 and the listed dimensional specifications, which supports accurate selection for service work. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.