PowerStop JBD1005P Brake Drum - Rear

Rear OE Replacement Brake Drum

PowerStop JBD1005P is a rear brake drum built as a direct bolt-on replacement for factory equipment. It is manufactured to original equipment specifications for fit, weight, and braking performance, with a high-temp coated finish to help resist rust and corrosion.

Compatible With 2006-2011 Hyundai Accent rear, 2006-2011 Kia Rio rear, and 2006-2011 Kia Rio5 rear applications, this Power Stop rear OE stock replacement coated brake drum supports a clean OE-style repair for common compact car drum brake setups.

Key Features

• Direct bolt-on replacement for factory rear brake drum applications
• Cast iron construction for OE-style braking service
• High-temp rust resistant coating helps protect against corrosion
• Manufactured to original equipment specifications for fitment, weight, and performance
• Inside diameter: 203.20 mm / 8.00 in
• Outside diameter: 243.20 mm / 9.60 in
• Maximum brake diameter (discard): 205.20 mm / 8.10 in
• 4-bolt hole design

Product Details

The Power Stop Autospecialty rear OE stock replacement coated brake drum is built for drivers who need a factory-style drum brake service part with correct dimensions and corrosion protection. The JBD1005P follows OE specifications so it matches the intended rear brake drum application on select Hyundai Accent, Kia Rio, and Kia Rio5 models from 2006 through 2011. This makes it a practical choice when replacing a worn, scored, or rusted rear drum on a vehicle that uses drum brakes at the rear.

This part cross-references Centric Parts 122.51013 and DuraGo BD920116 for the same application.

What It Helps Address

• Rear brake drum wear from normal braking use
• Rust and corrosion on the drum surface
• Brake pulsation caused by an out-of-spec drum
• Noise from a scored or uneven drum surface
• Reduced braking consistency from a damaged OE drum

Installation Notes and Tips

Verify rear drum brake dimensions and vehicle application before installation. The drum is intended for rear use on the listed Hyundai and Kia models, and the 4-bolt hole pattern should be matched to the vehicle’s original setup. Inspect related brake components for wear, contamination, or scoring during service so the new drum can operate against properly maintained hardware.

Quality Assurance

Power Stop manufactures this brake drum to original equipment specifications and applies a high-temperature coating for added protection against rust and corrosion. The JBD1005P is part of the Power Stop rear OE stock replacement coated brake drum line, focused on factory-style fitment and dependable replacement performance.