PowerStop JBD1009P Brake Drum - Rear

Rear OE Stock Replacement Brake Drum

PowerStop JBD1009P is a rear brake drum built as a direct bolt-on replacement for factory equipment. It is manufactured to original equipment specifications for fitment, weight, and performance, with a high-temp coated surface for added rust and corrosion protection.

Compatible with 2000-2006 Nissan Sentra rear brake applications, this Power Stop rear OE stock replacement coated brake drum supports a factory-style repair for drivers replacing worn or corroded drum components. The JBD1009P is a practical choice when you need OE-style dimensions and a corrosion-resistant finish for everyday braking service.

Key Features

• Direct bolt-on replacement for factory rear drum applications
• High-temp coated finish helps resist rust and corrosion
• Manufactured to original equipment specifications
• Cast iron construction for OE-style braking performance
• Inside diameter: 203.20 mm / 8.00 in
• Outside diameter: 236.00 mm / 9.30 in
• Maximum brake diameter (discard): 204.50 mm / 8.10 in
• 4-bolt hole design

Product Details

Power Stop’s Autospecialty coated brake drum line focuses on factory-style replacement parts with corrosion protection built into the finish. The JBD1009P follows original equipment specifications so it matches the intended fitment and braking geometry for the rear of the vehicle. For Nissan Sentra owners, this helps maintain a stock replacement setup without changing the drum brake design.

This part cross-references Centric Parts 122.42026 for the same application.

Common Reasons to Replace

• Rust or corrosion on the drum surface
• Brake pulsation or uneven rear braking feel
• Out-of-spec inside diameter from wear
• Noise caused by drum surface damage
• Restoring OE-style rear brake operation on a Nissan Sentra

Installation Notes and Tips

Verify rear drum brake measurements before installation, including inside diameter and discard diameter, to confirm the drum is within specification. Clean the hub and mating surfaces before mounting the new drum, and inspect related rear brake components for wear while the drum is removed. Fits 2000-2006 Nissan Sentra, rear.

Quality Assurance

Power Stop manufactures this brake drum to original equipment specifications and applies a rust-resistant coating for added surface protection. Part number JBD1009P is built for OE-style fitment and consistent rear brake service on the listed Nissan Sentra applications.