PowerStop L2645 Disc Brake Caliper - Front Right

Front Right OE Replacement Caliper

PowerStop L2645 is a front right disc brake caliper built as an OE stock replacement for select Honda and Acura applications. It is remanufactured for direct bolt-on replacement and uses a floating caliper design with a 64.24 mm steel piston, cast iron housing, and included mounting bracket.

Compatible with 1999-2004 Honda Odyssey front right and 2001-2002 Acura MDX front right, this PowerStop caliper is built for drivers replacing a worn, sticking, or leaking original unit. The gray finish, caliper slides, and bleeder screw thread size of M10 x 1.0 support a straightforward service replacement on the front right brake corner.

Key Features

• PowerStop Front OE Stock Replacement Caliper, part number L2645
• Front right disc brake caliper for select Honda Odyssey and Acura MDX applications
• Floating caliper design with one steel piston
• Cast iron caliper casting with gray finish
• Includes caliper slides and mounting bracket
• Remanufactured with new seals, dust boots, bleeder screws, and stainless steel brake pad abutment clips
• High-temperature EPDM rubber dust boots and silicone lubricant for smoother operation

Product Details

PowerStop’s Autospecialty OE Replacement Brake Calipers are remanufactured in Chicago, Illinois and assembled with new internal and service components for stock-style brake restoration. L2645 is pressure tested to verify piston movement and check for leaks before release. The design follows the original front right caliper layout for 1999-2004 Honda Odyssey and 2001-2002 Acura MDX models, making it a direct replacement choice for OE brake service. This part number, L2645, is a practical option when you need a front right caliper that matches the factory configuration without changing the brake system setup.

What It Helps Fix

• Brake drag caused by a sticking front right caliper
• Fluid leakage from a worn piston seal or bleeder area
• Uneven front brake pad wear
• Poor caliper slide movement
• Reduced braking response from a failing original caliper

Installation Notes

Verify vehicle fitment by year, make, model, and front right position before installation. Inspect brake pads, rotors, and brake hoses during service, and bleed the hydraulic system after caliper replacement. Confirm the bleeder screw thread size is M10 x 1.0 and transfer any required brake line or pad hardware only if your vehicle setup calls for it.

Quality Assurance

PowerStop remanufactures the caliper and bracket in its Chicago facility and pressure tests each unit to confirm piston operation and help prevent leaks. The caliper is assembled with new seals, slide pins where applicable, dust boots, bleeder screws, and stainless steel brake pad abutment clips for consistent OE-style service replacement.