PowerStop L2684A Disc Brake Caliper - Rear Right

Rear Right OE Replacement Caliper for Highlander

PowerStop L2684A is a rear right disc brake caliper built as a direct OE-style replacement for 2001-2003 Toyota Highlander applications. It is remanufactured in Chicago, pressure tested for piston operation and leak prevention, and assembled with new internal service components for consistent brake performance.

Key Features

• Fits 2001-2003 Toyota Highlander, rear right
• Floating caliper design with 1 steel piston
• 38.02 mm piston diameter
• Cast iron caliper body with gray finish
• Includes caliper slides and mounting bracket
• Uses M7 x 1.0 bleeder screw thread size
• Built with new seals, dust boots, bleeder screw, and stainless steel pad abutment clips
• High-temperature EPDM rubber dust boots and silicone lubricant for smoother operation

Detailed Description

PowerStop’s Autospecialty OE Replacement Brake Calipers are made for drivers who want a stock replacement brake solution for the Toyota Highlander without changing the original brake layout. Part number L2684A is remanufactured to OE-style specifications and inspected for piston movement and sealing integrity before it leaves the facility. The rear right caliper uses a floating design, cast iron construction, and a steel piston to match common factory brake system requirements.

This PowerStop rear OE stock replacement caliper line focuses on direct-fit service parts for everyday brake repairs. For Highlander owners searching for a rear right brake caliper replacement, L2684A provides the correct fitment for 2001, 2002, and 2003 models. This part cross-references Monroe Shocks & Struts (e.g., 172286) for the same application.

Common Problems This Part Can Address

• Brake fluid seepage from a worn caliper seal or piston area
• Uneven rear braking caused by a sticking caliper
• Poor pad movement from worn slides or abutment contact points
• Corrosion-related caliper binding on the rear right corner
• Reduced braking response from an aging OE caliper assembly

Installation Notes and Tips

Verify rear right fitment before installation on 2001-2003 Toyota Highlander models. Inspect brake pads, rotor condition, and brake hoses during service, and bleed the hydraulic system after caliper replacement. Confirm the bleeder screw thread size and bracket alignment during installation, and transfer only the components required by the vehicle service procedure.

Quality Assurance

PowerStop remanufactures this caliper and bracket assembly in Chicago, IL and pressure tests each unit to verify piston operation and help prevent leaks. New seals, slide pins where applicable, dust boots, bleeder screws, and stainless steel pad abutment clips are used during assembly to support consistent service quality.