PowerStop L2929 Disc Brake Caliper - Rear Left

Rear OE Replacement Caliper for Odyssey

PowerStop L2929 is a rear left disc brake caliper built as an OE stock replacement for 2005-2010 Honda Odyssey models. It bolts directly in place of the original caliper and is remanufactured for a straightforward brake service on the rear axle.

For Honda Odyssey rear brake repairs, this PowerStop caliper focuses on factory-style fitment, verified piston operation, and the hardware details that matter for consistent braking performance. The L2929 is a practical choice for restoring rear left brake function without changing the original brake setup.

Key Features

• Fits 2005-2010 Honda Odyssey, rear left
• OE stock replacement disc brake caliper
• Floating caliper design with one 40.39 mm piston
• Cast iron caliper body with gray finish
• Mounting bracket included
• Caliper slides included
• Steel piston material
• M10 x 1.25 bleeder screw thread size
• Remanufactured in Chicago, Illinois
• Pressure tested to confirm piston operation and check for leaks

Product Details

PowerStop’s Autospecialty OE Replacement Brake Calipers are remanufactured with new seals, dust boots, bleeder screws, stainless steel brake pad abutment clips, and slide pins where applicable. High-temperature EPDM rubber dust boots and premium silicone lubricant are used to support smooth caliper movement and durability in demanding conditions. Part number L2929 is built for drivers who want a direct-fit rear brake caliper for a Honda Odyssey with stock-style operation.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Caliper Can Address

• Rear left caliper sticking or dragging
• Uneven rear brake pad wear
• Brake fluid seepage at the caliper
• Reduced braking response from a worn piston or seal
• Noisy or rough caliper slide movement

Installation Notes

Verify rear left fitment before installation on 2005-2010 Honda Odyssey vehicles. Inspect brake pads, rotors, and brake hoses during service, and bleed the hydraulic system after caliper replacement. Confirm the bleeder screw thread size and bracket alignment match the original brake setup before final assembly.

Quality Assurance

PowerStop remanufactures the caliper and bracket in its Chicago, IL facility and pressure tests each unit to help verify piston operation and detect leaks before it leaves production. The caliper is assembled with new sealing components and corrosion-resistant brake pad contact hardware for consistent service quality.