PowerStop L4897 Disc Brake Caliper - Rear Left

OE Replacement Caliper Overview

PowerStop L4897 is a rear OE stock replacement disc brake caliper built for direct installation in place of the original unit. It is a remanufactured floating caliper with a cast iron body, phenolic piston, and included bracket and slides for the specified application.

Fits 2003-2008 Dodge Ram 3500, rear left. This PowerStop caliper is pressure tested and assembled with new seals, dust boots, bleeder screws, and stainless steel pad abutment clips for a complete stock-style brake service.

• Fits 2003-2008 Dodge Ram 3500, rear left, DRW.
• Floating caliper design with 2 pistons for consistent pad movement.
• Cast iron housing with a gray finish for a durable replacement build.
• Phenolic piston material and EPDM dust boots for smoother operation in demanding conditions.
• Inlet and bleeder screw threads are M10 x 1.0.

Detailed Product Information

PowerStop L4897 is intended for drivers replacing a worn or leaking rear brake caliper on a Dodge Ram 3500. The remanufactured design follows OE stock replacement dimensions and uses a floating caliper layout with a 50.85 mm piston diameter. PowerStop L4897 is assembled in Chicago, Illinois and pressure tested to confirm piston operation and help prevent leaks before installation. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Brake fluid seepage from a worn caliper body or seal.
• Uneven pad contact caused by sticking slides or piston movement issues.
• Reduced braking response from a damaged rear caliper assembly.
• Corrosion or wear on the original caliper housing and hardware.

Installation Notes and Tips

Verify the rear left fitment for 2003-2008 Dodge Ram 3500 DRW before ordering. Transfer and bleed the brake system according to service procedures after installation, and confirm the inlet and bleeder thread sizes match the vehicle connection points. Mounting hardware is not listed as included, so confirm reuse or replacement needs during service.

Quality Assurance

PowerStop remanufactures this caliper and bracket in its Chicago facility and pressure tests each unit to verify piston operation and check for leaks. New seals, slide pins where applicable, dust boots, bleeder screws, and stainless steel pad abutment clips are used during assembly to support consistent brake service quality.