PowerStop L6277 Disc Brake Caliper - Rear Left

Overview

PowerStop L6277 is a rear OE stock replacement disc brake caliper built for direct installation in the original mounting location. It is a floating caliper with a 38.00 mm piston, cast iron housing, and included bracket and slides for a complete stock-style replacement.

Fits 2010-2014 Subaru Legacy, rear left. Fits 2010-2014 Subaru Outback, rear left. This PowerStop caliper is a practical choice for Subaru Legacy and Subaru Outback brake service when you need a direct-fit hydraulic replacement.

Key Features

• Direct replacement caliper for OE-style brake service
• Floating design with one 38.00 mm piston
• Cast iron caliper body with steel piston
• Caliper slides and mounting bracket included
• Inlet and bleeder screw thread size: M10 x 1.0
• Gray finish for a clean service replacement appearance

Detailed Description

PowerStop Autospecialty OE Replacement calipers are remanufactured in Chicago, Illinois and assembled with new seals, dust boots, bleeder screws, and stainless steel brake pad abutment clips. The caliper is pressure tested to verify piston operation and check for leaks before release. High-temperature EPDM rubber dust boots and silicone lubricant are used to support smooth caliper movement in demanding conditions. Part number L6277 is a rear OE stock replacement caliper for Subaru Legacy and Subaru Outback applications listed below.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Uses

• Replacing a leaking or sticking brake caliper
• Restoring proper rear brake piston movement
• Addressing uneven brake pad wear from caliper drag
• Repairing corrosion or wear in the original caliper assembly

Installation Notes

Mounting hardware is not included. Verify inlet and bleeder thread sizes before installation. Confirm the vehicle application and rear left position match the listing before ordering. Part number L6277 should be matched to the existing brake setup during service.

Quality Assurance

PowerStop remanufactures this caliper and bracket assembly in its Chicago facility and pressure tests each unit to confirm piston operation and leak resistance. New seals, slide pins where applicable, dust boots, and bleeder screws are used during assembly for consistent service quality.