PowerStop L6886 Disc Brake Caliper - Rear Left

Rear Left OE Replacement Caliper

PowerStop L6886 is a rear left disc brake caliper built as a direct OE stock replacement for select Honda and Acura applications. It is remanufactured in Chicago, pressure tested for piston operation and leak prevention, and assembled with new internal service components for consistent brake performance.

Key Features

• Direct replacement disc brake caliper for the rear left position
• Cast iron caliper body with gray finish
• Floating caliper design with 1 steel piston
• 38.10 mm piston diameter
• Includes caliper slides and mounting bracket
• New seals, dust boots, bleeder screw, and stainless steel pad abutment clips installed during assembly
• High-temperature EPDM rubber dust boots and silicone lubricant for smoother operation
• Bleeder screw thread size: M10 x 1.25

Product Details

The PowerStop Autospecialty OE Replacement Brake Caliper line focuses on stock-style brake service parts for drivers who want a direct-fit repair without changing the original brake setup. Part number L6886 is built for rear left applications on 2013-2018 Acura RDX, 2012-2016 Honda CR-V, 2012-2015 Honda Crosstour, and 2010-2011 Honda Accord Crosstour. This PowerStop rear OE stock replacement caliper is a practical choice for restoring hydraulic braking function on vehicles that need an OE-style caliper assembly.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Leaking or sticking rear caliper piston
• Uneven rear brake pad wear
• Corrosion or seizure in the caliper housing
• Soft or inconsistent rear brake response
• Brake drag caused by worn slide components

Installation Notes

Compatible With 2013-2018 Acura RDX, rear left; 2012-2016 Honda CR-V, rear left; 2012-2015 Honda Crosstour, rear left; and 2010-2011 Honda Accord Crosstour, rear left. Verify rotor, pad, and hydraulic line condition before installation, and confirm bleeder screw thread size M10 x 1.25 during service. Because mounting hardware is not listed as included, reuse or replace related fasteners as needed based on the vehicle and brake service procedure.

Quality Assurance

PowerStop remanufactures the caliper and bracket in its Chicago, IL facility and pressure tests each unit to verify piston movement and help prevent leaks. Each caliper is assembled with new seals, slide pins where applicable, dust boots, bleeder screws, and stainless steel brake pad abutment clips for consistent OE-style service quality.