PowerStop L7096 Disc Brake Caliper - Rear Right

Rear Right OE Replacement Caliper

PowerStop L7096 is a rear right disc brake caliper for 2013-2017 Honda Accord applications. This OE stock replacement caliper is built for direct replacement service, with the fitment and hardware details needed for a straightforward brake repair on the Honda Accord rear right position.

Key Features

• Fits 2013-2017 Honda Accord, rear right
• PowerStop Autospecialty OE Replacement Brake Caliper line
• Floating caliper design with 1 piston
• 38.00 mm piston diameter
• Cast iron caliper body with gray finish
• Steel piston construction
• Caliper slides included
• Mounting bracket included
• Inlet thread size: M10 x 1.0
• Bleeder screw thread size: M10 x 1.25

Product Details

PowerStop’s Autospecialty OE Replacement Brake Calipers are remanufactured in Chicago, Illinois and assembled with new seals, slide pins where applicable, dust boots, bleeder screws, and stainless steel brake pad abutment clips. The caliper is pressure tested to verify piston operation and check for leaks before it leaves the facility. High-temperature EPDM rubber dust boots and silicone lubricant are used to support smooth movement and long service life in demanding conditions. PowerStop L7096 is a practical OE-style replacement for drivers servicing a Honda Accord rear brake system and looking for a direct-fit caliper assembly.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Leaking rear brake caliper on a 2013-2017 Honda Accord
• Sticking or seized rear right caliper piston
• Uneven rear brake pad wear on the Honda Accord
• Corrosion or damage to the original rear caliper housing
• Brake drag or reduced rear braking performance

Installation Notes

Verify rear right fitment before installation and confirm thread sizes match the vehicle brake line and bleeder screw connections. Transfer or replace related brake components as needed during service, and bleed the hydraulic system after installation to remove air from the brake circuit. Inspect pads, rotors, and hoses for wear or damage while servicing the caliper.

Quality Assurance

PowerStop remanufactures this caliper and bracket assembly in its Chicago facility and pressure tests each unit for piston function and leak prevention. The use of new internal seals, dust boots, bleeder screws, and related assembly components supports consistent OE-style brake service for the Honda Accord rear right application.