PowerStop Z47-1775 Disc Brake Pad Set - Rear

Rear Brake Pads for Transit Fleet Use

PowerStop Z47-1775 rear brake pads are built for Ford Transit vans that work at full GVW on a daily basis. This rear disc brake pad set uses a semi-metallic, carbon-fiber reinforced friction formula to support consistent stopping performance and lower cost-per-mile in medium-duty and last-mile fleet service.

Compatible With 2015-2019 Ford Transit-150, rear; 2015-2019 Ford Transit-250, rear; 2015-2019 Ford Transit-350, rear; and 2015-2019 Ford Transit-350 HD, rear. The Z47-1775 part number is also listed under OE cross-reference numbers CK4Z 2200-A, CK4Z 2200-B, and CK4Z 2200-C for the same application.

Key Features

• Semi-metallic friction material with carbon-fiber reinforcement
• Rear disc brake pad set for severe-duty fleet braking demands
• Mechanical friction attachment to the backing plate for high shear resistance
• Chamfered edges for smoother pad engagement
• Scorched friction surface for quicker bedding
• Pad shims included for added noise control support
• Premium stainless-steel hardware included
• Outer and inner pad thickness: 17.6 mm

Product Details

The Power Stop Z47 MD and Fleet line is focused on medium-duty and last-mile vehicles that spend long hours in service and frequently operate near maximum load. On the Ford Transit-150, Transit-250, Transit-350, and Transit-350 HD, these rear pads are engineered as an upgrade over stock brake pads with a compound built for durability, stable friction, and reduced downtime. The mechanically attached friction layer adds backing-plate retention strength, while the included stainless-steel hardware supports a cleaner brake service on the rear axle.

Common Problems These Pads Address

• Reduced rear braking performance on loaded Ford Transit vans
• Brake fade during repeated stop-and-go fleet driving
• Premature pad wear from daily full-GVW operation
• Noise and vibration from worn rear disc pads
• Extended service intervals caused by heavy-duty use

Installation Notes and Tips

Verify rear fitment by year, model, and position before installation. Inspect rotors, calipers, and slide hardware for wear or uneven contact before fitting new pads. Clean the caliper bracket and pad contact points, then follow the vehicle service procedure for bedding-in the new friction material after installation. The pad wear sensor is not included, and brake lubricant is not included.

Quality Assurance

PowerStop designs the Z47 MD and Fleet brake pad line for severe-duty commercial service, with a semi-metallic carbon-fiber compound, chamfered edges, scorched friction surfaces, and stainless-steel hardware included for service convenience. Part number Z47-1775 is built for rear brake applications on the listed Ford Transit models.