Prenco 4D-1064 Engine Crankshaft Position Sensor

Crankshaft Position Sensor for Saab 9-5 and 9-3

Prenco 4D-1064 is an engine crankshaft position sensor built for direct replacement on select Saab applications. It uses a 3-wire, blade-terminal design with a rectangular female connector and a 20.5-inch wiring harness for a clean OE-style connection.

Compatible With 1996-2009 Saab 900, 1999-2003 Saab 9-3, and 1999-2009 Saab 9-5 applications, this sensor supports accurate crankshaft signal input for engine management. The Prenco 4D-1064 is a practical choice when diagnosing crank signal faults on Saab 9-5 and Saab 9-3 models.

Key Features

• Engine crankshaft position sensor for ignition and engine timing systems
• 3-wire construction with 3 blade terminals
• Rectangular female connector for OE-style fitment
• 20.5-inch wiring harness length
• Sensor body diameter: 0.7
• Mounting bracket not included
• Cross-references Beck/Arnley 180-0472 and Bosch 0261210269 for the same application

Detailed Description

The Prenco 4D-1064 crankshaft position sensor monitors crankshaft position and sends the signal used by the engine control system for spark and fuel timing. It is specified with a single rectangular connector, male blade terminals, and a female connector housing to match the original-style electrical interface on covered Saab vehicles. This part number is also referenced in Saab 9-5 and Saab 9-3 service applications where a crankshaft signal sensor is required.

Fits 1999-2009 Saab 9-5, N/A. Fits 1999-2003 Saab 9-3, N/A. Fits 1996-1998 Saab 900, N/A, w/distributor. Prenco 4D-1064 is a direct-fit replacement option for drivers searching for a Saab crankshaft position sensor, Saab 9-5 crank sensor, or Saab 9-3 engine speed sensor replacement.

What It Helps Address

• Crankshaft position signal loss
• Hard starting or no-start conditions related to crank signal failure
• Intermittent stalling tied to engine timing input issues
• Check engine light concerns associated with crank sensor faults
• Rough running caused by inaccurate engine speed data

Installation Notes and Tips

Verify connector shape, terminal style, and harness length before installation. Inspect the mating connector and wiring for corrosion, heat damage, or broken terminals, and confirm the sensor mounting location matches the vehicle application. On 1996-1998 Saab 900 applications, note the w/distributor fitment requirement.

Quality Assurance

Prenco supplies this sensor as an OE-style replacement part for the listed Saab applications. Confirm part number 4D-1064 against the vehicle’s original sensor and connector configuration before installation.