PRT Performance Ride 170264 Suspension Shock Absorber - Front or Rear

PRT Shock Absorber 170264 Overview

PRT Performance Ride shock absorber 170264 is a gas-charged suspension shock absorber built for controlled damping and consistent ride response. It features a 2.01-inch body diameter, a 9.33-inch stroke, and a metal dust shield to help protect the shaft area from road debris.

PRT Shock Absorber line components are engineered for direct suspension service where OE-style mounting and travel dimensions matter. This unit uses a bolt upper mount and loop lower mount, with a center-of-the-loop body end measuring point and stage-of-the-bolt rod end measuring point for accurate application matching.

Key Features

• Part number 170264 from PRT Performance Ride
• Gas charged for stable damping response
• Extended length: 23.23 inches
• Compressed length: 13.90 inches
• Shock stroke / travel length: 9.33 inches
• Upper mount type: bolt
• Lower mount type: loop
• Dust shield included; boot not included
• Metal dust shield material
• Non-adjustable design

Detailed Description

PRT Performance Ride 170264 is a suspension shock absorber intended for vehicles that use a bolt upper mount and loop lower mount configuration. The gas-charged construction supports controlled compression and rebound, while the 9.33-inch stroke and 23.23-inch extended length help match suspension travel requirements. With a 2.01-inch body diameter and integrated metal dust shield, this shock absorber is built for service in demanding road conditions where debris protection and consistent damping are important. If you are searching for a PRT shock absorber 170264 for suspension repair, this part number should be verified against the original equipment dimensions before installation. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Excessive bouncing after bumps or dips
• Unstable ride control during braking or cornering
• Worn damping performance from an aging shock absorber
• Road noise or harshness caused by suspension wear
• Reduced suspension control on vehicles using this mount style

Installation Notes and Tips

Confirm compressed length, extended length, stroke, and mount style before ordering. Verify the upper bolt mount and lower loop mount match the original shock absorber on the vehicle. Check surrounding suspension components, including bushings and mounting points, for wear before installation. For fitment-based searches, use terms such as PRT 170264 shock absorber, suspension shock absorber for make/model applications, and OE-style rear or front shock replacement only after confirming the exact vehicle position.

Quality Assurance

PRT Performance Ride shock absorber 170264 is built as a suspension service part with gas-charged construction and a protective dust shield for added durability in everyday use. Verify all dimensions and mounting points against the vehicle application before installation.