PRT Performance Ride 170366 Suspension Shock Absorber - Front

Front Shock Absorber for Select Dodge and Toyota

PRT Performance Ride 170366 is a front suspension shock absorber built for specific Dodge Ram 50 and Toyota Van applications. It uses a gas-charged design with a dust shield and boot to support controlled damping and help protect the rod from road debris.

Key Features

• PRT Shock Absorber line component for front suspension service
• Gas charged construction for consistent damping response
• Extended length: 14.25 in.; compressed length: 9.37 in.
• Shock stroke / travel length: 4.88 in.
• Upper mount type: bolt; lower mount type: loop
• Dust shield included with PE dust shield material
• Boot included for added rod protection
• Non-adjustable design
• Body diameter: 1.61 in.

Detailed Description

PRT Performance Ride 170366 is a front suspension shock absorber engineered for direct replacement service on 1992-1993 Dodge Ram 50 and 1984-1986 Toyota Van models. The PRT Shock Absorber line focuses on OE-style fitment and straightforward installation geometry, with a bolt upper mount, loop lower mount, and measured end points that match the listed applications. This part number, 170366, is a practical choice when replacing a worn front shock on a Dodge Ram 50 or Toyota Van with the specified front suspension setup.

The gas-charged internal design helps maintain damping consistency, while the included boot and dust shield add protection against dirt and debris. With 4.88 inches of travel and a 14.25-inch extended length, this shock absorber is sized for the confirmed front fitments listed below. Part number 170366 is also a useful reference when searching for a front shock absorber for 1992-1993 Dodge Ram 50 or 1984-1986 Toyota Van applications.

What It Helps Address

• Excessive front-end bounce after hitting bumps
• Reduced ride control from a worn shock absorber
• Front suspension noise caused by degraded damping components
• Uneven handling response during braking or cornering
• Rod contamination from dirt and road spray

Installation Notes and Tips

Verify the upper bolt mount and lower loop mount before installation, and compare the compressed and extended lengths to the removed part. Confirm front-position fitment on the vehicle before ordering. For best results, inspect related suspension components such as bushings and mounting points during replacement. Fits 1992-1993 Dodge Ram 50, front. Fits 1984-1986 Toyota Van, front.

Quality Assurance

PRT Performance Ride manufactures this shock absorber as part of its PRT Shock Absorber line for listed vehicle applications. Part number 170366 is built to match the confirmed fitment and mounting configuration shown above.