PRT Performance Ride 193805 Shock Absorber - Rear

Rear Shock Absorber for Toyota Tundra

PRT Performance Ride 193805 is a gas-charged rear suspension shock absorber for 2000-2006 Toyota Tundra applications. It is built with a loop lower mount and bolt upper mount, along with a metal dust shield for added protection in rear suspension service.

Key Features

• Fits 2000-2006 Toyota Tundra, rear
• PRT Shock Absorber line component from PRT Performance Ride
• Gas charged design for consistent damping response
• Extended length: 22.09 in; compressed length: 13.70 in
• Shock stroke / travel length: 8.39 in
• Upper mount type: bolt; lower mount type: loop
• Dust shield included; metal dust shield material
• Body diameter: 1.77 in
• Non-adjustable design; coil over springs not included; boot not included

Product Details

PRT Performance Ride 193805 is a rear suspension shock absorber engineered for Toyota Tundra trucks from 2000 through 2006. The PRT Shock Absorber product line focuses on direct-fit suspension replacement parts, and this unit uses the specified bolt-and-loop mounting configuration to match the rear application. Its gas-charged construction and 8.39-inch stroke support controlled suspension movement, while the metal dust shield helps protect the shock body in exposed underbody conditions. This part number, 193805, is a straightforward replacement choice for Toyota Tundra rear shock service.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems It Can Address

• Rear-end bounce or excessive oscillation over uneven pavement
• Reduced damping control from a worn Toyota Tundra rear shock absorber
• Noise or instability caused by suspension wear at the rear axle
• Uneven ride quality during load changes or towing
• Loss of suspension control from a fatigued gas-charged shock

Installation Notes and Tips

Verify rear fitment by matching the 2000-2006 Toyota Tundra application, mounting style, and dimensional specs before installation. Inspect the upper bolt mount and lower loop mount points for wear, and replace any damaged mounting hardware or bushings as needed during service. Confirm that the compressed length, extended length, and shock stroke align with the vehicle’s rear suspension travel before final tightening.

Quality Assurance

PRT Performance Ride 193805 is built as a suspension shock absorber for the listed Toyota Tundra rear applications and follows the stated mounting and dimensional specifications for fitment verification.