PWR 42-1051 Rack and Pinion Assembly

PWR 42-1051 Rack and Pinion for Jeep Liberty

PWR 42-1051 is a hydraulic rack and pinion assembly built for direct-fit replacement on 2002-2005 Jeep Liberty models. It is engineered for straightforward installation and is tested for leaks, pressure, noise, and function before release.

Key Features

• Hydraulic rack and pinion assembly
• Direct-fit design for easier installation
• Fits 2002-2005 Jeep Liberty
• Inner tie rods included
• Gasket or seal included
• USA engineering approved
• End-to-end length: 1247
• Total turns lock to lock: 3.4
• Steering input shaft diameter: 18.4
• Inlet fitting: 16 mm female
• Outlet fitting: 18 mm female

Product Details

This PWR rack and pinion assembly, part number 42-1051, is made for steering service on the Jeep Liberty platform from 2002 through 2005. It uses a hydraulic design with female inlet and outlet line fittings, and it includes inner tie rods and seals for a more complete steering gear replacement. This part cross-references Continental 64243 for the same application.

Common Steering Issues Addressed

• Steering play or looseness in the front end
• Fluid leakage from the rack and pinion assembly
• Rough, inconsistent, or noisy steering operation
• Worn internal steering gear components
• Loss of steering response caused by a failing hydraulic rack

Installation Notes and Tips

Verify line fitting sizes, steering shaft diameter, and mounting hole layout before installation. Because mounting hardware and mounting brackets are not included, reuse or source the correct vehicle-specific hardware as needed. After installation, bleed the hydraulic system and inspect for leaks, proper steering effort, and centered wheel position.

Quality Assurance

PWR states that its racks and gears are tested for leaks, pressure, noise, and function, and this assembly is USA engineering approved. That testing focus supports consistent steering performance on Jeep Liberty applications.