PWR 42-1855 Rack and Pinion Assembly

PWR 42-1855 Hydraulic Rack and Pinion

PWR 42-1855 is a hydraulic rack and pinion assembly built for direct-fit replacement on select Subaru applications. It is engineered for easier installation and is tested for leaks, pressure, noise, and function before release.

Compatible with Subaru Baja and Subaru Outback steering systems, this rack and pinion assembly supports precise hydraulic steering response for 2000-2004 Subaru Outback and 2003-2006 Subaru Baja applications. The PWR 42-1855 is a practical replacement choice when restoring steering feel on these vehicles.

Key Features

• Hydraulic rack and pinion assembly
• Direct-fit design for easier installation
• USA engineering approved
• 100% tested for leaks, pressure, noise, and function
• Gasket or seal included
• Inner tie rods included
• 20-spline steering input shaft
• 1182 end-to-end length
• 3.1 turns lock to lock

Detailed Description

This PWR steering rack is built to match the hydraulic steering layout used in select Subaru models. It features female inlet and outlet line fittings, an 18 mm steering input shaft diameter, and a 14 mm inlet with a 16 mm outlet line fitting diameter. The assembly is intended for Subaru Outback and Subaru Baja fitments where a direct replacement rack and pinion is needed, and the included inner tie rods help simplify the rebuild process.

This part cross-references 34110AE12A and 262401 for the same application.

Common Steering Issues This Part Can Address

• Excessive steering play or loose steering feel
• Fluid leakage from a worn rack and pinion assembly
• Noise during steering input
• Uneven or inconsistent hydraulic steering response
• Worn internal steering components on Subaru Outback and Subaru Baja models

Installation Notes and Tips

• Verify fitment by year and model before installation: Fits 2000-2004 Subaru Outback and Fits 2003-2006 Subaru Baja.
• Inspect hydraulic lines, seals, and related steering components during replacement.
• Confirm spline count, shaft diameter, and line fitting sizes match the original unit.
• Professional alignment is recommended after steering rack replacement.
• Mounting hardware and mounting brackets are not included.

Quality Assurance

PWR states that this rack and pinion assembly is USA engineering approved and individually tested for leaks, pressure, noise, and function to support consistent steering performance.