PWR 42-1932 Rack and Pinion Assembly

PWR 42-1932 Rack and Pinion Assembly

The PWR 42-1932 is a hydraulic rack and pinion assembly for select Dodge Sprinter vans. It is built as a direct-fit replacement to simplify installation and is engineered for consistent steering response in daily service.

Compatible with 2003-2006 Dodge Sprinter 2500 and 2003-2006 Dodge Sprinter 3500, this rack and pinion assembly is a practical choice for restoring steering control on high-mileage commercial vans. The PWR 42-1932 is also cross-referenced to 262145 and 972145 for the same application.

Key Features

• Hydraulic rack and pinion assembly
• Direct-fit design for easier installation
• USA engineering approved
• 100% tested for leaks, pressure, noise, and function
• Gasket or seal included
• Inner tie rods included
• 4 mounting holes
• 54-spline steering input shaft
• Female inlet and outlet line fittings

Detailed Description

This steering rack is built for the Dodge Sprinter 2500 and Dodge Sprinter 3500 from 2003 through 2006. It uses a hydraulic design with a 17.5 mm steering input shaft, 14 mm inlet fitting, 16 mm outlet fitting, and 3.9 turns lock to lock. The assembly measures 1469 end to end and includes inner tie rods, while outer tie rods, mounting hardware, and mounting brackets are not included.

PWR 42-1932 is intended for owners replacing a worn or leaking steering gear on a Sprinter van and looking for a direct-fit rack and pinion assembly that matches the original hydraulic layout. The part number 42-1932 is a useful reference when verifying the correct steering gear for 2003-2006 Dodge Sprinter 2500 and 3500 applications.

Common Issues This Part Addresses

• Steering fluid leaks from a worn rack and pinion assembly
• Excessive steering play or loose steering feel
• Noise during steering input
• Uneven or inconsistent steering response
• Failure of internal rack seals or hydraulic components

Installation Notes and Tips

Confirm fitment by matching the vehicle year, model, and steering connection details before installation. Transfer or replace related steering components as needed during service, and inspect hydraulic lines, tie rod ends, and alignment settings after the rack is installed. Because this assembly uses female inlet and outlet fittings, verify line connection sizes before beginning the job.

Quality Assurance

PWR states that its racks and gears are tested for leaks, pressure, noise, and function before release. The manufacturer also identifies this unit as USA engineering approved for direct-fit service.