PWR 42-2009 Rack and Pinion Assembly

PWR 42-2009 Rack and Pinion Assembly

The PWR 42-2009 is a hydraulic rack and pinion assembly built for direct-fit replacement in select Ford and Mercury steering applications. It is engineered and tested in the USA for leak resistance, pressure performance, noise control, and overall function.

Compatible With 2002-2005 Ford Explorer and 2002-2005 Mercury Mountaineer, this rack and pinion assembly supports precise steering response for left-hand-drive vehicles where listed.

Key Features

• Hydraulic rack and pinion assembly for steering system service
• Direct-fit design for easier installation
• USA engineering approved
• 100% tested for leaks, pressure, noise, and function
• Gasket or seal included
• Inner tie rods included
• Female inlet and outlet line fittings
• 3.9 total turns lock to lock

Detailed Description

PWR part number 42-2009 is a hydraulic steering rack assembly intended for vehicles that require a direct replacement rack with the correct input shaft, line fitting sizes, and steering geometry. The assembly measures 1283 end to end, uses a 18.4 steering input shaft diameter, and includes inner tie rods while omitting outer tie rods, mounting hardware, and mounting brackets. This part cross-references Continental 64247 for the same application.

For Ford Explorer and Mercury Mountaineer steering repair, PWR 42-2009 provides a service-ready replacement option that matches the listed fitment and hydraulic connection requirements. It is a practical choice when restoring steering feel, correcting rack wear, or replacing a leaking unit on the specified vehicles.

What It Helps Fix

• Steering fluid leaks from a worn rack and pinion assembly
• Excessive steering play or loose steering response
• Noise or rough operation from internal rack wear
• Uneven steering effort caused by hydraulic rack failure
• Restoration needs on a Ford Explorer or Mercury Mountaineer steering system

Installation Notes and Tips

Verify the vehicle uses the listed hydraulic steering configuration before installation. Confirm inlet and outlet line fitting sizes, steering input shaft diameter, and end-to-end length against the original unit. Because mounting hardware and mounting brackets are not included, reuse or source the required installation components as needed. Professional alignment is recommended after steering rack replacement.

Fits 2002-2004 Ford Explorer, left hand drive. Fits 2005 Ford Explorer. Fits 2002-2005 Mercury Mountaineer.

Quality Assurance

PWR states that this rack and pinion assembly is USA engineering approved and individually tested for leaks, pressure, noise, and function before release. That testing focus supports consistent steering-system performance for the listed applications.