PWR 42-2118 Rack and Pinion Assembly

PWR 42-2118 Rack and Pinion for Honda Ridgeline

PWR 42-2118 is a hydraulic rack and pinion assembly for the 2006-2014 Honda Ridgeline. It is built as a direct-fit replacement to simplify installation and restore steering response in the Honda Ridgeline steering system.

Key Features

• Hydraulic rack and pinion assembly
• Direct-fit design for easier installation
• USA engineering approved
• 100% tested for leaks, pressure, noise, and function
• Includes inner tie rods
• Gasket or seal included
• 36-spline steering input shaft
• 3.3 turns lock to lock
• Female inlet and outlet line fittings

Detailed Description

This PWR rack and pinion assembly, part number 42-2118, is engineered for the 2006-2014 Honda Ridgeline and uses a hydraulic steering design. It features a 1344 end-to-end length, 17.3 steering input shaft diameter, and 16 mm female inlet and outlet fittings for a direct replacement application. The assembly includes inner tie rods and a gasket or seal, while mounting hardware, mounting brackets, and outer tie rods are not included.

This part cross-references Anchor 3326 for the same application. It also cross-references 8050N for related replacement use. For Honda Ridgeline steering repair, PWR 42-2118 provides a direct-fit option built around the original vehicle configuration.

Common Problems This Part Can Address

• Steering play or looseness in the Honda Ridgeline
• Fluid leakage from a worn rack and pinion assembly
• Noisy or rough hydraulic steering operation
• Uneven steering response during turning
• Wear in the original rack, seals, or internal steering components

Installation Notes and Tips

Verify spline count, line fitting size, and overall rack dimensions before installation. Transfer or replace any required external components not included with the assembly, and inspect hydraulic lines, tie rods, and steering linkage for wear while the system is apart. After installation, bleed the power steering system and confirm proper steering wheel center and alignment.

Quality Assurance

PWR states that its pumps, racks, and gears are tested for leaks, pressure, noise, and function before release. This rack and pinion assembly is USA engineering approved and built for direct-fit replacement use on the 2006-2014 Honda Ridgeline.