PWR 42-2287 Rack and Pinion Assembly

PWR 42-2287 Rack and Pinion Assembly

PWR 42-2287 is a hydraulic rack and pinion assembly built for direct-fit replacement on select Subaru steering applications. It is engineered and tested for leak resistance, pressure performance, noise control, and steering function, making it a practical choice for restoring precise steering response.

Compatible With 2005-2009 Subaru Legacy, 2005-2009 Subaru Outback, 2008 Subaru Impreza, and 2009 Subaru Impreza built to 09/21/08. This PWR rack and pinion assembly is a direct-fit solution for Subaru Legacy, Subaru Outback, and Subaru Impreza steering repair.

• Hydraulic rack and pinion assembly for power steering systems
• Direct-fit design for easier installation and OE-style replacement
• Inner tie rods included
• Gasket or seal included
• USA engineering approved and fully tested for leaks, pressure, noise, and function
• 20-spline steering input shaft with 17.3 mm diameter
• 3.2 turns lock-to-lock for responsive steering feel
• Female inlet and outlet line fittings

Detailed Product Overview

Built as a hydraulic steering gear replacement, PWR 42-2287 is intended to restore steering control in vehicles that use a rack and pinion setup. The assembly measures 1210 mm end to end and uses a 2-hole mounting pattern, with inner tie rods included and outer tie rods not included. It also features female inlet and outlet fittings, a 14 mm inlet line fitting diameter, and a 16 mm outlet line fitting diameter for application-specific plumbing.

This part cross-references Maval 93206M for the same application.

Common Steering Issues It Can Address

• Excessive steering play or delayed steering response
• Fluid leakage from a worn rack and pinion unit
• Noise during steering input from internal wear
• Uneven or inconsistent steering effort
• Worn internal steering components affecting road feel

Installation Notes and Tips

Verify the steering input shaft spline count, shaft diameter, and line fitting sizes before installation. Because mounting hardware and mounting brackets are not included, reuse or source the correct vehicle-specific hardware as needed. Always inspect the hydraulic lines, seals, and tie rod connections during replacement, and confirm alignment after installation.

Quality Assurance

PWR states that this rack and pinion assembly is USA engineering approved and individually tested for leaks, pressure, noise, and function before release.