PWR 42-2294 Rack and Pinion Assembly

PWR 42-2294 Rack and Pinion Assembly

The PWR 42-2294 is a hydraulic rack and pinion assembly built for direct-fit replacement on select Kia Sportage and Hyundai Tucson applications. It is engineered for straightforward installation and is fully tested for leaks, pressure, noise, and function before release.

Key Features

• Hydraulic rack and pinion assembly for steering system replacement
• Direct-fit design for easier installation on listed applications
• USA engineering approved
• Gasket or seal included
• Mounting brackets included
• Inner tie rods included
• 36-spline steering input shaft with 18 mm diameter
• 16 mm female inlet and outlet line fittings
• 3.1 turns lock-to-lock

Detailed Description

This PWR rack and pinion assembly, part number 42-2294, is built for hydraulic steering systems and matches the listed fitment for 2005-2010 Kia Sportage and 2005-2008 Hyundai Tucson, plus 2009 Hyundai Tucson built through 04/01/2009. The assembly includes inner tie rods, mounting brackets, and seals, helping support a complete steering gear replacement on the correct vehicle application. PWR 42-2294 is also cross-referenced to Cardone New 97-2416 and Cardone Reman 26-2416 for the same application.

Vehicle Fitment

• Fits 2005-2010 Kia Sportage, N/A
• Fits 2005-2008 Hyundai Tucson, N/A
• Fits 2009 Hyundai Tucson, N/A, to 04/01/2009

Common Steering Issues This Part Addresses

• Excessive steering play or loose steering feel
• Fluid leakage from the rack and pinion assembly
• Noise during steering input
• Uneven or inconsistent steering response
• Worn internal steering gear components

Installation Notes and Tips

Verify hydraulic line fitting size, steering input shaft spline count, and overall length before installation. This assembly uses female inlet and outlet fittings and includes mounting brackets, but mounting hardware is not listed as included. Always inspect related steering components, flush the hydraulic system as needed, and confirm alignment after replacement.

Quality Assurance

PWR states that this rack and pinion assembly is tested for leaks, pressure, noise, and function, and that the unit is USA engineering approved. The direct-fit design is intended to simplify installation on the specified Kia Sportage and Hyundai Tucson applications.