PWR 42-2464 Rack and Pinion Assembly

PWR 42-2464 Hydraulic Rack and Pinion Assembly

PWR 42-2464 is a direct-fit hydraulic rack and pinion assembly for steering service on select Hyundai Accent and Dodge Attitude models. It is engineered for straightforward installation and built as a tested replacement for leak control, pressure performance, noise, and steering function.

Key Features

• Hydraulic rack and pinion assembly for steering system repair
• Direct-fit design for easier installation
• USA engineering approved
• Gasket or seal included
• Mounting brackets included
• Inner tie rods included
• 36-spline steering input shaft
• 3.1 turns lock to lock
• Female inlet and outlet line fittings

Detailed Description

This PWR rack and pinion assembly, part number 42-2464, is built for hydraulic steering systems and matches the fitment requirements for 2006-2011 Hyundai Accent and 2006-2011 Dodge Attitude. The assembly includes inner tie rods, gasket or seal components, and mounting brackets, while outer tie rods and mounting hardware are not listed as included. With a 1047 end-to-end length, 18 mm steering input shaft diameter, and 14 mm inlet / 16 mm outlet line fittings, it is specified for direct replacement service on the original steering layout.

This part cross-references Anchor 3381 for the same application. It is also referenced by part number 42-2464 in service and catalog listings for Hyundai Accent and Dodge Attitude steering repair.

Vehicle Fitment

• Fits 2006-2011 Dodge Attitude, N/A
• Fits 2006-2011 Hyundai Accent, N/A

Common Repair Uses

• Steering play or looseness in the wheel
• Hydraulic rack leakage at seals or fittings
• Noise during steering input
• Uneven or inconsistent steering response
• Wear-related failure in the rack and pinion assembly

Installation Notes and Tips

Verify the 36-spline input shaft, 18 mm shaft diameter, and female inlet/outlet fitting sizes before installation. Confirm the vehicle’s steering system configuration against the original unit, and inspect related lines, tie rods, and mounting points during replacement. Because mounting hardware is not listed as included, reuse or replace fasteners as needed based on the vehicle and service procedure.

Quality Assurance

PWR states that this rack and pinion assembly is tested for leaks, pressure, noise, and function before release. The manufacturer also identifies the unit as USA engineering approved for steering service applications.