Raybestos BH36901 Brake Hydraulic Hose - Front

Brake Hydraulic Hose for Reliable Fluid Transfer

Raybestos Element3 BH36901 is a brake hydraulic hose built for secure brake fluid transfer between the hard line and the caliper connection. It uses a male thread fitting on one end and a banjo fitting on the other, with a 12.000-inch overall length for the specified application.

The Raybestos Element3 line focuses on brake components engineered for consistent service performance, and this hose follows that approach with a direct-fit configuration for the listed vehicle application. If you are replacing a worn brake hose on a Honda Civic or similar application, BH36901 provides the connection style and length needed for a proper hydraulic repair.

Key Features

• Brand: Raybestos
• Brand line: Element3
• Part number: BH36901
• Brake hydraulic hose for brake system fluid routing
• Male thread fitting at end 1
• Banjo fitting at end 2
• 12.000-inch overall hose length
• Gasket or seal included: Yes

Detailed Product Overview

BH36901 is a brake hose assembly intended for hydraulic brake service where a flexible connection is required between rigid brake lines and the wheel-end brake component. The male thread and banjo fitting combination is common in brake applications that require a secure, sealed connection at the caliper side. This part cross-references Dorman - First Stop H36901 for the same application.

For buyers searching by vehicle fitment, this Raybestos brake hose is a practical match for Honda Civic brake hose replacement needs when the application calls for the listed connection style and hose length. The Raybestos BH36901 part number is also useful when comparing replacement options against OE-style brake hose references.

Common Problems This Part Can Address

• Cracked or aging brake hose material
• Brake fluid seepage at hose connections
• Restricted fluid flow from internal hose deterioration
• Soft or inconsistent brake pedal feel caused by hose wear
• Corrosion or damage at the hose-to-fitting interface

Installation Notes and Tips

Confirm the fitting types, hose length, and seal requirements before installation. Brake hydraulic hoses should be routed without twists, kinks, or contact with moving suspension parts, and all connections should be tightened to the vehicle manufacturer’s specifications. After installation, bleed the brake system and inspect for leaks at both ends.

Quality Assurance

Raybestos Element3 brake components are built for brake service applications that require accurate fit and dependable hydraulic connection points. Verify the part number BH36901 against the vehicle’s brake hose configuration before installation.