Raybestos BH380197 Brake Hydraulic Hose - Rear Right

Rear Right Brake Hose for Mazda Miata

Restore hydraulic brake performance with the Raybestos Element3 BH380197 brake hydraulic hose. This rear right hose is built with a block-style SAE fitting on one end and a banjo fitting on the other, with a 14.800-inch overall length for the specified Mazda Miata applications.

Compatible with 1990-1997 Mazda Miata, rear right, and 1999-2005 Mazda Miata, rear right. The Raybestos Element3 BH380197 is a direct-fit hydraulic hose choice for Miata brake service where correct routing, sealing, and connection style matter.

Key Features

• Brake hydraulic hose for rear right placement
• Raybestos Element3 product line
• End 1 fitting type: Block - SAE
• End 2 fitting type: Banjo
• Overall hose length: 14.800 inches
• Gasket or seal included: Yes
• Cross-references Dorman - First Stop H380197 and Beck/Arnley 073-1558 for the same application

Product Details

The Raybestos Element3 BH380197 is a brake hydraulic hose engineered for Mazda Miata rear right applications across the 1990-1997 and 1999-2005 model years. The Element3 line focuses on brake service components that match the required fitment and connection style for the vehicle, helping maintain proper hydraulic transfer between the hard line and brake assembly. Use BH380197 when servicing a rear right Miata brake hose that requires a block SAE end, a banjo end, and the listed hose length.

For Mazda Miata brake repair, correct hose fitment is critical to maintaining pedal response and secure fluid routing. The BH380197 part number is also a useful reference when comparing replacement options for the same rear right application.

Common Problems This Hose Can Address

• Cracked or deteriorated rear brake hose material
• Brake fluid seepage at the hose connection points
• Restricted hydraulic flow from an aging hose
• Soft or inconsistent brake pedal feel caused by hose wear
• Incorrect hose length or fitting style during brake service

Installation Notes and Tips

Verify rear right placement before installation and compare the original hose routing, fitting style, and overall length to the new part. Inspect the mating surfaces, replace worn seals as needed, and confirm all connections are clean before tightening. After installation, bleed the brake system according to the vehicle service procedure and check for leaks at both ends.

Quality Assurance

Raybestos Element3 brake components are built for application-specific fitment and service consistency. The BH380197 includes a gasket or seal, supporting a proper connection at the specified brake hose interfaces.