Raybestos BH383922 Brake Hydraulic Hose - Rear Right

Raybestos Element3 Brake Hydraulic Hose BH383922

Raybestos Element3 BH383922 is a brake hydraulic hose built for direct brake fluid transfer at the wheel end. It features a female thread SAE fitting on one end, a banjo fitting on the other, and an overall length of 12.100 inches for applications that require this hose configuration.

Key Features

• Brake hydraulic hose for brake system fluid routing
• Female Thread - SAE fitting at end 1
• Banjo fitting at end 2
• Overall hose length: 12.100 inches
• Gasket or seal included: Yes
• Raybestos Element3 line component

Element3 Product Line

The Raybestos Element3 line is positioned for brake service applications that require accurate fit, consistent hydraulic connection points, and application-specific hose construction. BH383922 follows that approach with the listed end fittings and seal inclusion for the specified brake hose setup.

Detailed Description

BH383922 is a Raybestos brake hydraulic hose intended for vehicles that use a female thread SAE connection on one end and a banjo connection on the other. This configuration is commonly used in brake hose routing where the hose must connect securely to the hard line and caliper-side hardware. For buyers searching for a Raybestos BH383922 brake hose, this part number identifies the exact hose configuration and length needed for the application.

This part cross-references Centric Parts 150.65461 for the same application.

What It Is Used For

• Replacing a leaking or cracked brake hose
• Restoring brake fluid flow between the chassis line and wheel-end connection
• Addressing soft pedal feel caused by hose deterioration
• Correcting brake hose fitment when the original hose uses a banjo end and SAE female thread end

Installation Notes and Tips

Verify the hose length, end fittings, and routing before installation. Confirm that the banjo connection and SAE female thread match the original brake hose on the vehicle. Inspect mating surfaces and replace worn seals or damaged hardware as needed during brake service. For vehicle-specific searches, use terms such as Raybestos BH383922 brake hydraulic hose, brake hose with banjo fitting, and female thread SAE brake hose replacement.

Quality Assurance

Raybestos Element3 brake components are cataloged by application and fitting style to support accurate brake service selection. Confirm fitment against the vehicle’s original hose configuration before installation. Compatible With select brake hose applications, including make/model searches for Ford and Honda vehicles where this hose style is specified.