Rein BEM0039P Drive Shaft Center Support Bearing

OE Quality Drive Shaft Support Bearing

The Rein BEM0039P drive shaft center support bearing is an application-specific replacement for vehicles that use a 55mm outside diameter and 30mm inside diameter bearing. It is built for BMW, Mercedes-Benz, Mini, and Rolls-Royce driveline applications where center support bearing service is required.

• Application-specific fitment for confirmed vehicle listings
• OE-quality replacement for driveline center support bearing service
• 55mm O.D. and 30mm I.D. configuration
• Made in the USA
• Rein BEM0039P cross-references Timken SET102 for the same application

Detailed Product Overview

This drive shaft center support bearing is used in a wide range of rear- and all-wheel-drive driveline layouts across BMW 330i, BMW X3, Mercedes-Benz E350, and Mini Cooper Countryman applications, along with many other listed models. The Rein BEM0039P is an OE-quality replacement built around the specified bearing dimensions, making it a direct match for vehicles that require the 55mm O.D. and 30mm I.D. center support bearing configuration.

Rein BEM0039P also cross-references Timken SET102 for the same application. Confirm fitment by year, make, model, and bearing dimensions before ordering.

Common Problems This Part Addresses

• Driveline vibration from a worn center support bearing
• Excessive driveline movement under load
• Noise from a deteriorated bearing carrier
• Harshness felt through the floor or tunnel area
• Service replacement for a failed BMW, Mercedes-Benz, Mini, or Rolls-Royce center support bearing

Installation Notes and Tips

• Verify the bearing dimensions match 55mm O.D. and 30mm I.D. before installation.
• Inspect the driveshaft, carrier mount, and surrounding driveline components for wear during service.
• Installation hardware is not included.
• Use the vehicle’s exact year and model listing to confirm application-specific fitment.

Quality Assurance

Rein supplies OE-quality driveline components, and this part is manufactured in the United States. The BEM0039P is built to meet the dimensional requirements listed for the confirmed applications, including BMW, Mercedes-Benz, Mini, and Rolls-Royce models.