Rein BKN0124 CV Joint Boot Kit - Front Inner or Rear Inner

Rein OE Quality CV Boot Kit BKN0124

Rein BKN0124 is an application-specific CV joint boot kit for front inner and rear inner axle service. It is built to match original equipment design specifications and includes OE grease plus the hardware needed for a proper repair, helping restore the protective seal around the CV joint on select Audi, Volkswagen, and Volkswagen e-Golf applications.

Key Features

• Application-specific fit for select front inner and rear inner CV axle positions
• Includes the hardware needed for the complete repair, such as clamps, washers, and clips
• Supplied with OE grease
• Boot is manufactured from high-quality materials to resist cracking, wear, and leakage
• Matches original equipment design specifications

Detailed Description

The Rein BKN0124 CV joint boot kit is made for drivers and technicians replacing a damaged or leaking axle boot before contamination reaches the joint. A torn boot can allow dirt, sand, and moisture to enter the CV joint, leading to accelerated wear and driveline noise. This kit is built for direct-fit service on vehicles such as the Audi A3, Audi A3 Quattro, Audi Q5, Audi TT Quattro, Volkswagen GTI, Volkswagen Jetta, Volkswagen Passat, and Volkswagen e-Golf, with coverage for both front inner and rear inner positions where listed. This part cross-references Volkswagen OE part number 1K0498201A for the same application. Rein BKN0124 is a practical OE-style repair choice when you need a replacement boot that follows factory design requirements.

Common Repair Reasons

• Split or cracked CV boot
• Grease leakage around the axle joint
• Road debris contamination inside the CV joint
• Clicking or vibration caused by a worn boot that was not serviced in time
• Preventive repair after inspection of a damaged axle boot

Installation Notes and Tips

Inspect the CV joint for wear before installing the new boot. Clean the axle and joint thoroughly, then pack the joint with the supplied OE grease and secure the boot using the included hardware. Because installation instructions are not included, follow the vehicle service procedure for the specific Audi or Volkswagen application and verify the correct front inner or rear inner position before assembly.

Quality Assurance

Rein manufactures this boot kit to OE design specifications using materials selected to help prevent cracking, wear, and leakage during normal driveline service. The application-specific design supports a proper first-time fit on the listed Audi, Volkswagen, and Volkswagen e-Golf vehicles.