Rein BKN0181 CV Joint Boot Kit - Front Inner or Rear Inner

OE-Quality CV Boot Kit for Axle Service

Rein BKN0181 is an application-specific CV joint boot kit for inner and outer axle service. It is built to match original equipment design specifications and includes the grease and hardware needed for a proper repair on supported Volkswagen Passat and Audi Quattro applications.

Key Features

• Application-specific fit for a direct repair on confirmed vehicle listings
• Includes clamps, washers, clips, and related hardware for the complete service
• Supplied with OE grease for CV joint lubrication
• Boot is made from high-quality materials to help resist cracking, wear, and leakage
• Matches original equipment design specifications
• Black boot construction

Detailed Description

The Rein BKN0181 CV boot kit is a replacement solution for protecting the CV joint from dirt, sand, and other contaminants that can damage the joint when the boot is compromised. This kit is intended for inner axle boot service on 1999-2005 Volkswagen Passat, rear inner, 2000-2001 Audi A4 Quattro, front inner, 1998-2001 Audi A6 Quattro, rear inner, and 1999 Audi A4 Quattro, front inner from VIN 8DX200001. It is also a direct-reference option for OE part number 8D0498201. Rein BKN0181 is built for service work where correct fitment and OE-style construction matter.

Fits 1999-2005 Volkswagen Passat, rear inner. Fits 2000-2001 Audi A4 Quattro, front inner. Fits 1998-2001 Audi A6 Quattro, rear inner. Fits 1999 Audi A4 Quattro, front inner from VIN 8DX200001.

This part cross-references 8D0498201 for the same application.

Common Problems This Part Addresses

• Split or cracked CV boot
• Grease leakage around the axle joint
• Contamination from road debris entering the joint
• Noise or vibration caused by a worn boot and lost lubrication
• Need for a direct-fit boot service on listed Audi and Volkswagen models

Installation Notes and Tips

Inspect the CV joint before installation to confirm the joint is still serviceable. Clean the axle area thoroughly, pack the joint with the supplied grease, and secure the boot with the included hardware according to the vehicle-specific procedure. Because installation instructions are not included, use the correct service manual for torque values, clamp positioning, and boot alignment.

Quality Assurance

Rein application-specific axle boot kits are built to OE design specifications and use materials selected to help prevent cracking, wear, and leakage during normal service.