Rein CHR0914 Engine Coolant Hose - Oil Cooler (Lower) To Pipe

OE-Style Coolant Hose for Vanagon

Rein CHR0914 is an engine coolant hose built for European vehicle cooling systems that require an OE-style direct replacement. It matches the original hose shape and branch sizing, and it uses thermoplastic quick-connect fittings for a factory-style fit on the application.

Compatible With 1986-1991 Volkswagen Vanagon, oil cooler (lower) to pipe. This Rein CHR0914 coolant hose is specified for the Vanagon cooling circuit where the lower oil cooler connection routes to the pipe.

Key Features

• Direct replacement engine coolant hose for the listed Volkswagen Vanagon application
• OE-quality construction with factory-matched size and branch geometry
• Thermoplastic quick-connect fittings for the original connection style
• Black coolant hose finish
• Hose end 1 outside diameter: 21.39 mm; inside diameter: 15.75 mm
• Hose end 2 outside diameter: 17.93 mm; inside diameter: 10.54 mm
• Part number CHR0914 for catalog and fitment verification

Detailed Description

Rein CHR0914 is an OE-quality replacement coolant hose for 1986-1991 Volkswagen Vanagon models in the oil cooler (lower) to pipe position. Rein designs this hose to mirror the original equipment layout, including the branch dimensions and connector style, so the hose follows the factory routing used in the Vanagon cooling system. If you are replacing a worn, cracked, or leaking hose on a Volkswagen Vanagon, CHR0914 provides the correct application-specific shape and connection points. The part number CHR0914 also cross-references 025121058D for the same application.

Common Problems This Hose Can Address

• Coolant leakage at the oil cooler lower hose connection
• Cracking or hardening from age and heat cycling
• Improper hose routing caused by a distorted original hose
• Loose or damaged quick-connect interface at the factory-style fitting
• Cooling system service needs on a Volkswagen Vanagon

Installation Notes and Tips

Verify the hose routing and connection points against the removed part before installation. Confirm the hose end diameters and the oil cooler (lower) to pipe position on the vehicle, and inspect adjoining pipes, clamps, and seals for wear before reassembly. On a Volkswagen Vanagon, proper seating of the quick-connect fittings is important for a secure cooling system connection. Use the part number CHR0914 to confirm the correct replacement before installation.

Quality Assurance

Rein manufactures this hose as an OE-quality replacement for European vehicles, with dimensions and connector style matched to the original hose assembly. CHR0914 is built to the same application-specific standards expected for factory-style cooling system service on the Volkswagen Vanagon.