Rein PSH0571 Power Steering Pressure Line Hose Assembly

OE-Style Power Steering Hose Assembly

Rein PSH0571 is a direct-fit power steering pressure line hose assembly for select Toyota Tundra applications. It is built for OE-style replacement where the high-pressure feed and return routing must match the original vehicle layout and connection points.

Compatible With 2007-2021 Toyota Tundra and 2013 Toyota Tundra built from 8/13, this assembly is designed to reduce labor time during replacement while maintaining the factory-style fit and function expected in a steering hydraulic line.

Key Features

• Direct-fit replacement hose and line assembly
• SAE J188 compliant high-pressure rubber hose with internal noise absorber
• SAE J526 compliant heavy-duty tubing and end fittings with corrosion-resistant coating
• Pre-assembled coated hose crimp ends and brackets where required
• Protective jacket(s) and heat sleeve(s) included where required
• OE-quality construction for Toyota Tundra power steering service

Detailed Product Overview

The Rein PSH0571 power steering pressure line hose assembly is engineered to replace the original high-pressure feed and return hose on the Toyota Tundra. Rein uses SAE J188 compliant rubber compound hose and SAE J526 compliant tubing sections, along with heavy-duty carbon steel end fittings finished for rust resistance. The assembly also incorporates an internal noise absorber and OE-specified brackets, sealing hardware, and pressure switch provisions where applicable to match the factory configuration.

This part cross-references Toyota 444100C110 and 444100C111 for the same application. For buyers searching for a Toyota Tundra power steering pressure hose, high-pressure feed line, or OE replacement steering hose assembly, PSH0571 provides a direct-fit solution.

Common Problems This Part Can Address

• Power steering fluid leaks from a worn or damaged pressure line
• Steering noise caused by hose deterioration or internal restriction
• Corrosion at the tubing or end fittings
• Loss of steering assist from pressure-line failure
• Fitment issues after replacing a factory steering hose with an incorrect line

Installation Notes and Tips

Verify the vehicle build date before ordering, especially for 2013 Toyota Tundra models built from 8/13. Compare the original hose routing, bracket locations, and pressure switch configuration to the replacement assembly before installation. Always inspect related steering components, flush contaminated fluid if needed, and confirm all connections are clean and properly seated during service.

Quality Assurance

Rein tests these high-pressure hose assemblies for tensile strength, burst pressure, low-temperature flexibility, impulse durability, and corrosion resistance. PSH0571 is backed by a 24-month/24,000-mile warranty.