SKF 11429 Wheel Seal - Rear Inner

SKF Wheel Seal 11429 for Honda and Acura

SKF 11429 is a wheel seal built for driveline and axle sealing applications where consistent lubricant retention matters. It uses a nitrile sealing surface and precise dimensions to match the specified shaft and housing requirements for select Honda Civic, Civic del Sol, Integra, CRX, Prelude, and Accord applications.

Key Features

• Part number: SKF 11429
• Wheel seal for driveline and axle sealing systems
• Nitrile sealing surface type for the specified application
• Width: 0.315 in.
• Outside diameter: 1.781 in.
• Shaft diameter: 1.142 in.
• Designed for select Honda Civic and Acura Integra fitments

Application Details

SKF has a long history in seal engineering, and this wheel seal reflects that experience with application-specific design and premium material selection. The 11429 is built to help maintain proper sealing performance in vehicles that rely on accurate wheel-end and axle sealing, including Honda Civic, Honda Civic del Sol, Acura Integra, Honda CRX, Honda Prelude, and Honda Accord models listed below. This part cross-references 1402Y and 91213P2FA01 for the same application.

• Fits 1997-2005 Honda Civic, N/A
• Fits 1983-1992 Honda Civic, N/A
• Fits 1993-1998 Honda Civic, N/A, w/ SOHC Eng.
• Fits 1993-1997 Honda Civic del Sol, N/A, w/ SOHC Eng.
• Fits 1992-1993 Acura Integra, N/A
• Fits 1988-1991 Honda CRX, N/A
• Fits 1983-1990 Honda Prelude, N/A
• Fits 1984-1989 Honda Accord, N/A

Common Issues This Seal Addresses

• Gear oil or lubricant seepage at the wheel-end seal area
• Contamination entering the sealed hub or axle interface
• Wear-related sealing loss from age or heat exposure
• Noise or roughness caused by compromised sealing surfaces
• Service repeat repairs when the original seal no longer holds properly

Installation Notes and Tips

Verify shaft diameter, outside diameter, and width before installation to confirm the seal matches the service opening. Inspect the sealing surface and surrounding components for scoring, corrosion, or debris, and clean the bore thoroughly before pressing the seal into place. For best results, follow the vehicle service procedure for the specific Honda or Acura application and confirm the seal seats evenly.

Quality Assurance

SKF manufactures seals to defined application standards using premium materials selected for the operating environment. The brand’s seal engineering focus and long production history support consistent fit and sealing performance for the specified vehicles.