SKF 12386 Drive Axle Shaft Seal - Front Right

SKF Drive Axle Shaft Seal 12386

SKF 12386 is a drive axle shaft seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. With a nitrile sealing surface and precise shaft and outside dimensions, it supports a secure seal at the axle shaft interface.

Fits 2006-2011 Honda Civic, front right. Fits 2006-2011 Honda Civic, front left. Fits 2006-2011 Honda Civic, rear right. Fits 2006-2011 Honda Civic, rear left. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Key Features

• Drive axle shaft seal for driveline and axle sealing systems
• Nitrile sealing surface type for sealing performance in automotive service conditions
• 1.250 shaft diameter for the specified axle shaft interface
• 1.878 outside diameter for proper housing fitment
• 0.250 width for a compact seal profile
• SKF part number 12386 for direct catalog identification

Detailed Description

SKF 12386 is engineered as a drive axle shaft seal for vehicles that require dependable sealing at the axle shaft. SKF has a long history in seal design and manufacturing, and this seal reflects that experience with application-specific dimensions and premium material selection. The nitrile sealing surface is chosen for automotive sealing environments where lubricant retention and contaminant exclusion are critical. For shoppers searching for a Honda Civic axle shaft seal, Honda Civic driveline seal, or SKF 12386 replacement seal, this part provides a focused OE-style sealing solution.

What It Helps Address

• Gear oil or lubricant seepage at the axle shaft seal area
• Contamination entering the driveline or axle housing
• Seal wear from age, heat, and normal road exposure
• Noise or driveline concerns associated with low lubricant levels
• Service replacement needs for a worn Honda Civic axle seal

Installation Notes and Tips

Verify shaft diameter, outside diameter, and seal width before installation to confirm the seal matches the housing and axle shaft dimensions. Inspect the sealing surface and surrounding components for wear, scoring, or contamination before fitting the new seal. Clean the bore thoroughly and install the seal squarely to avoid distortion. Confirm the application against the vehicle service information for the exact axle position.

Quality Assurance

SKF designs and manufactures seals to high quality standards, using application-specific construction intended to support long service life and safe operation. Part number 12386 is built to the dimensional and material requirements listed for this seal application.