SKF 12582 Wheel Seal - Rear Inner

SKF Rear Inner Wheel Seal 12582

SKF 12582 is a rear inner wheel seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. With a nitrile sealing surface and precise dimensional sizing, it is suited for service work on vehicles that need a dependable wheel seal replacement.

For technicians and parts buyers searching for a rear inner wheel seal for Honda Civic or similar axle service applications, SKF 12582 provides the dimensional details needed to match the job correctly. The SKF Wheel Seal - Rear Inner line is engineered around application-specific sealing requirements and material selection.

Key Features

• Part number 12582 for easy identification and ordering
• Rear inner wheel seal design for axle and hub sealing service
• Nitrile sealing surface type for oil-resistant sealing performance
• Outside diameter: 2.254 in.
• Shaft diameter: 1.250 in.
• Width: 0.250 in.
• SKF seal construction based on long-running sealing engineering experience

Product Details

SKF has a long history in seal design and manufacturing, and this wheel seal reflects that focus on precise fit and material selection. The nitrile sealing surface is specified for sealing environments where lubricant retention and contaminant exclusion are critical. With its defined outside diameter, shaft diameter, and width, SKF 12582 is intended for axle and wheel-end service where exact dimensions matter.

This part cross-references CHR 12582 and QX22259 for the same application. Buyers looking for a rear inner wheel seal for Honda Civic service can use the part number 12582 to verify the correct replacement during axle or hub maintenance.

Common Problems This Seal Can Address

• Gear oil or lubricant leakage at the wheel end
• Contamination entering the axle or hub area
• Seal wear from age, heat, and road exposure
• Noise or service issues related to compromised sealing
• Maintenance replacement during driveline or axle repair

Installation Notes and Tips

Confirm shaft diameter, outside diameter, and width before installation to match the original seal dimensions. Inspect the sealing surface, hub, and axle components for wear or scoring before pressing in the new seal. Clean the mating surfaces thoroughly and install the seal squarely to avoid distortion. For Honda Civic rear inner wheel seal service, verify the application by part number and axle configuration before assembly.

Quality Assurance

SKF manufactures seals to defined design and material standards, using premium materials selected for the application and operating environment. The brand’s sealing expertise and long-term focus on lubricant retention and contamination control support consistent service performance. Part number 12582 is built to the same dimensional and material specifications expected in professional driveline and axle repair.