SKF 12760 Manual Transmission Seal - Rear

SKF 12760 Manual Transmission Seal

SKF 12760 is a manual transmission seal built for shaft sealing in transmission and drivetrain service. It uses a nitrile sealing surface and precise dimensions to help maintain lubricant retention while keeping dirt and moisture out.

Key Features

• Manual transmission seal for transmission sealing applications
• Nitrile sealing surface type for dependable contact at the shaft
• Outside diameter: 2.211 in.
• Shaft diameter: 1.260 in.
• Width: 0.315 in.
• SKF engineering and manufacturing standards for consistent fit and service life

Detailed Description

SKF 12760 is a transmission seal designed around specific dimensional requirements: 1.260-inch shaft diameter, 2.211-inch outside diameter, and 0.315-inch width. Those measurements matter in manual transmission service because the seal must match the shaft and housing accurately to control lubricant at the sealing point. SKF’s long history in seal design is reflected in this part’s focused construction and material selection. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

For buyers searching for a manual transmission seal for SKF 12760, or a transmission shaft seal with nitrile sealing material, this part is built for service where lubricant retention and contamination control are critical. It is a direct-fit style sealing component for transmission repair work on vehicles such as Honda Civic and Honda Accord applications where the correct seal dimensions are required.

What It Helps Address

• Transmission fluid seepage at the shaft seal area
• Contamination entering the manual transmission housing
• Wear-related sealing loss from an aged or hardened seal
• Leak diagnosis tied to a damaged transmission output or input seal
• Service replacement during manual transmission repair

Installation Notes and Tips

Confirm shaft diameter and housing dimensions before installation. Inspect the sealing surface for scoring, burrs, or corrosion, and clean the bore thoroughly so the seal seats evenly. Lubricate the sealing lip with clean transmission fluid during assembly and verify proper alignment to avoid premature wear. Always compare the removed seal to SKF 12760 before final installation.

Quality Assurance

SKF manufactures seals to specific designs using premium materials and controlled production standards. The brand’s seal development history and focus on long service life support dependable use in manual transmission repair.