SKF 13662 Wheel Seal - Rear Outer

SKF 13662 Wheel Seal for Driveline Service

SKF 13662 is a wheel seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. With a nitrile sealing surface, a 1.375 shaft diameter, 2.129 outside diameter, and 0.250 width, this seal is specified for precise sealing performance in service environments that demand consistent contact and durability.

Key Features

• Part number 13662 wheel seal from SKF
• Nitrile sealing surface for dependable sealing contact
• 1.375 shaft diameter for application-specific fit
• 2.129 outside diameter and 0.250 width
• Engineered for driveline and axle sealing systems
• Supports lubricant retention and contaminant exclusion

Detailed Description

SKF has a long history in seal engineering, and the 13662 reflects that focus with a design built around material selection and dimensional accuracy. This wheel seal is made to help maintain the sealing interface in axle and wheel-end service, keeping lubricants in place while helping block dirt, water, and other contaminants. For technicians searching for an SKF wheel seal 13662, or for a direct replacement in vehicle service work, the listed dimensions are the key reference points for proper selection. It is a practical choice for driveline repairs on applications such as International Harvester and Case equipment where the correct seal profile is critical.

This part cross-references DN1066 and MX85391 for the same application.

What It Helps Address

• Gear oil or lubricant seepage at the wheel end
• Contamination entering the axle or hub area
• Seal wear from age, heat, and road exposure
• Noise or rough operation caused by compromised sealing
• Service repeat failures from incorrect seal dimensions

Installation Notes and Tips

Verify shaft diameter, outside diameter, and seal width before installation. Inspect the sealing surface and housing for scoring, corrosion, or debris, and clean all mating surfaces before pressing the seal into place. Confirm the seal is seated squarely to avoid uneven wear and premature leakage. For fitment-based searches, use the exact vehicle and axle specifications rather than relying on appearance alone. SKF 13662 is commonly searched for wheel seal replacement on International Harvester and Case applications, so matching the original dimensions is essential.

Quality Assurance

SKF manufactures seals to defined design and material standards, using premium compounds selected for the application and operating environment. The brand’s seal engineering heritage includes decades of development focused on long service life and reliable sealing performance. Part number 13662 is produced to support consistent quality in wheel-end and axle sealing service.