SKF 13761A Transfer Case Output Shaft Seal - Rear

SKF Transfer Case Output Shaft Seal 13761A

SKF 13761A is a transfer case output shaft seal built for rear-position Subaru applications that need reliable fluid retention at the transfer case. It is engineered with a polyacrylate sealing surface and precise dimensions to match the shaft and housing interface.

• Transfer case output shaft seal for rear applications
• Polyacrylate sealing surface type for consistent contact at the shaft
• Outside diameter: 1.977 in.
• Shaft diameter: 1.376 in.
• Width: 0.426 in.
• SKF part number 13761A for direct identification

Fitment Coverage

• Fits 1998-2014 Subaru Forester, rear
• Fits 1993-2014 Subaru Impreza, rear
• Fits 1990-2014 Subaru Legacy, rear
• Fits 2000-2014 Subaru Outback, rear
• Fits 2008-2014 Subaru Tribeca, rear
• Fits 2013-2014 Subaru XV Crosstrek, rear
• Fits 2006-2007 Subaru B9 Tribeca, rear
• Fits 2003-2006 Subaru Baja, rear

Detailed Description

SKF 13761A is a rear transfer case output shaft seal designed for Subaru drivetrains across Forester, Impreza, Legacy, Outback, Tribeca, XV Crosstrek, B9 Tribeca, and Baja models. The seal’s dimensions and polyacrylate sealing surface are specified to support proper fit at the output shaft, helping maintain the transfer case’s fluid barrier where the shaft exits the housing. This part cross-references Monroe Shocks & Struts (e.g., 806735210) for the same application.

SKF has a long history in shaft seal engineering, and this seal reflects that experience with application-specific design and premium material selection. The SKF 13761A part number is useful when matching the correct seal for rear transfer case service on Subaru vehicles.

What It Helps Address

• Transfer case fluid seepage at the output shaft
• Contamination entering the transfer case through a worn seal
• Leak-related low fluid condition at the rear output area
• Seal wear from age, heat, and drivetrain movement
• Service replacement during transfer case maintenance

Installation Notes and Tips

Confirm shaft diameter, outside diameter, and width before installation to verify the seal matches the housing and output shaft. Inspect the shaft surface for grooves or damage, and clean the sealing area thoroughly before fitting the new seal. Proper seating and alignment are important to avoid premature leakage after service.

Quality Assurance

SKF manufactures seals to defined design and material standards for long service life and dependable sealing performance. Part number 13761A is built for the listed Subaru rear applications and follows SKF’s established seal engineering approach.