SKF 14950 Automatic Transmission Output Shaft Seal - Right

SKF 14950 Output Shaft Seal Overview

SKF 14950 is an automatic transmission output shaft seal built for the right side of select compact vehicles. It is specified with a 1.496 shaft diameter, 2.126 outside diameter, and a 0.354 width, with a polyacrylate sealing surface for transmission sealing performance.

Compatible With 2004-2014 Chevrolet Aveo, right; 2006-2011 Chevrolet Aveo5, right; 2009-2010 Pontiac G3, right; 2005-2008 Pontiac Wave, right; and 2004-2008 Suzuki Swift+, right. This part number is also referenced as SKF 14950.

Key Features

• Automatic transmission output shaft seal for the right-side application
• Polyacrylate sealing surface type
• 1.496 shaft diameter for application-specific fit
• 2.126 outside diameter and 0.354 width
• SKF-engineered seal design for transmission fluid retention and contamination control
• Cross-reference part number: 93741870

Detailed Description

SKF 14950 is designed for transmission output shaft sealing where precise dimensions matter. The seal helps maintain the transmission’s internal lubricant path while limiting the entry of road debris and other contaminants. SKF has a long history in seal engineering, and this part reflects that focus through premium material selection and application-specific construction. If you need an output shaft seal for a Chevrolet Aveo, Chevrolet Aveo5, Pontiac G3, Pontiac Wave, or Suzuki Swift+ on the right side, SKF 14950 matches the listed fitment.

Common Problems This Seal Can Address

• Transmission fluid leaking at the output shaft area
• Fluid seepage that leaves residue around the transaxle housing
• Contamination entering the transmission through a worn seal
• Seal hardening, cracking, or wear from age and heat
• Noise or drivability concerns caused by low transmission fluid level

Installation Notes and Tips

Confirm the shaft diameter, outside diameter, and seal width before installation. Inspect the output shaft surface for scoring or wear, and clean the sealing bore thoroughly before pressing in the new seal. Verify right-side fitment against the vehicle application before assembly. For best results, replace the seal only after the source of leakage has been identified and the mating surfaces are in good condition.

Quality Assurance

SKF manufactures seals to specific design standards using premium materials selected for the application and operating environment. The brand’s seal engineering background supports consistent fit and long service life in transmission service.