SKF 15649 Wheel Seal - Rear Inner
OE Quality 60-Day Returns
SKF

SKF 15649 Wheel Seal - Rear Inner

Brand SKF 15649
Position Rear Inner
Width 0.250
Outside Diameter 2.506
Sealing Surface Type Nitrile
Shaft Diameter 1.563
Fits —

Nitrile sealing surface. Helps keep lubricants in and contaminants out.

Precision seal design. Made to specific designs for the application and environment.

SKF heritage. Built on decades of seal development and bonding innovation.

Cross-references 127979R91 for the same application. See all 1.

$22.25Free shipping
In stock · usually ships same day before 1pm CST
Step 1 — Confirm fitment
Free return shipping if it doesn't fit when you check fitment here first.

Select your vehicle to confirm fitment
Verify this part fits before purchasing — free returns if it doesn't
Step 2 — Quantity
Order total $22.25
Free shipping to the continental U.S.
Free returns within 60 days if it doesn't fit when fitment is verified.
Not what you need? See all Wheel Seal options

SKF 15649 Wheel Seal for Driveline Sealing

SKF 15649 is a wheel seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. With a nitrile sealing surface and precise dimensions, it supports a proper seal at the wheel end for service work on vehicles such as Honda Civic and Toyota Corolla applications where the correct seal size is critical.

  • Wheel seal for driveline and axle sealing service
  • Nitrile sealing surface type for dependable contact at the sealing interface
  • Outside diameter: 2.506 in.
  • Shaft diameter: 1.563 in.
  • Width: 0.250 in.
  • SKF part number 15649 for direct identification during replacement

Dimensions and Application Details

SKF 15649 is specified with a 2.506-inch outside diameter, 1.563-inch shaft diameter, and 0.250-inch width. Those measurements are important when selecting a wheel seal because the seal must match the housing and shaft dimensions to maintain proper sealing performance. SKF designs its seals with application-specific materials and bonding methods, and this part reflects that approach for wheel-end service on vehicles including Honda Civic and Toyota Corolla.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Wheel Seal Helps Address

  • Gear oil or lubricant leakage at the wheel end
  • Contamination entering the hub or axle area
  • Seal wear from age, heat, or road exposure
  • Noise or service issues related to poor sealing
  • Replacement needs during axle, hub, or bearing service

Installation Notes and Tips

Confirm shaft diameter, outside diameter, and width before installation so SKF 15649 matches the original seal dimensions. Inspect the sealing surface, hub bore, and shaft for wear or scoring before assembly, and clean the mating surfaces thoroughly. Proper seating is important for a wheel seal, so install it squarely to avoid distortion and premature leakage. The part number 15649 should be verified against the removed seal and service information for the vehicle.

Quality Assurance

SKF has a long history in seal engineering and manufactures seals to specific designs using premium materials for the intended operating environment. SKF 15649 is produced to high quality standards to support long service life and safe operation in wheel-end sealing applications.

This part fits 0 vehicles
Always verify fitment with your vehicle's VIN if unsure. Submodel & trim restrictions may apply.
YearMakeModelPositionNotes
Directly replaces or cross-references 1 part number
Cross-reference numbers are provided for identification purposes only. Always confirm fitment before ordering.
127979R91