SKF 16449 Wheel Seal - Rear

SKF 16449 Wheel Seal Overview

SKF 16449 is a wheel seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. With a nitrile sealing surface and precise dimensional sizing, it supports dependable sealing performance in service.

Compatible With wheel seal applications on vehicles such as Chrysler 16040 cross-reference use cases, this SKF wheel seal is identified by part number 16449 and is engineered to match the shaft and housing dimensions required for proper sealing.

Key Features

• Nitrile sealing surface for reliable contact and fluid control
• Outside diameter: 2.535 in.
• Shaft diameter: 1.618 in.
• Width: 0.438 in.
• SKF engineering and manufacturing standards for sealing systems
• Part number 16449 for accurate ordering and replacement lookup

Detailed Description

SKF has a long history in seal design, and this wheel seal reflects that experience with a construction focused on keeping lubricants in and contaminants out. The nitrile sealing surface is selected for sealing performance in demanding driveline and axle environments, while the listed dimensions help confirm proper fit during replacement. For buyers searching for an SKF 16449 wheel seal, or comparing SKF 16449 against other wheel seal references, the dimensional data is essential for matching the application.

This part cross-references Chrysler 16040 for the same application.

Common Issues This Part Helps Address

• Gear oil or grease leakage at the wheel end
• Contamination entering the hub or axle sealing area
• Wear-related sealing loss from an aged wheel seal
• Noise or service issues caused by lubricant loss
• Replacement needs during axle or hub service

Installation Notes and Tips

Verify shaft diameter, outside diameter, and width before installation to confirm the seal matches the hub or axle assembly. Inspect the sealing surface and mating components for scoring, corrosion, or debris before pressing the seal into place. Clean the sealing area thoroughly and follow the vehicle service procedure for the specific make and model.

Fits 2006-2011 Honda Civic, front right only when the vehicle application matches the listed seal dimensions and service requirements. Fits 2006-2011 Honda Civic, rear only when the vehicle application matches the listed seal dimensions and service requirements. Fits 2006-2011 Honda Civic, front left only when the vehicle application matches the listed seal dimensions and service requirements.

Quality Assurance

SKF manufactures seals to specific designs using premium materials and established quality standards. The brand’s seal development history and focus on long service life support confident replacement selection for driveline and axle sealing work.