SKF 19244 Manual Transmission Seal - Rear

SKF Manual Transmission Seal 19244 for Jeep Rear Applications

SKF 19244 is a manual transmission seal built for rear-position Jeep applications that need reliable fluid retention at the transmission output. With a polyacrylate sealing surface and precise dimensional sizing, this seal is specified for select Jeep Grand Wagoneer, J10, J20, CJ5, CJ7, Cherokee, Scrambler, and Wagoneer models.

Key Features

• Manual transmission seal for rear installation
• Polyacrylate sealing surface type for controlled sealing performance
• Outside diameter: 2.690 in.
• Shaft diameter: 1.938 in.
• Width: 0.304 in.
• SKF part number 19244 for direct identification

Detailed Description

SKF 19244 is engineered as a manual transmission seal for rear applications where the shaft and housing dimensions must match closely to maintain a dependable seal. The listed measurements, including a 1.938-inch shaft diameter, 2.690-inch outside diameter, and 0.304-inch width, help support accurate selection for service work on Jeep driveline components. SKF has a long history in seal design and uses premium materials and application-specific construction methods to produce seals for demanding operating environments. This part cross-references BBB Industries 11459 and Bosch 13672 for the same application.

Compatible With rear manual transmission service on Jeep Grand Wagoneer, Jeep J10, Jeep J20, Jeep CJ5, Jeep CJ7, Jeep Cherokee, Jeep Scrambler, and Jeep Wagoneer applications listed below. The SKF 19244 seal is a practical choice when replacing a worn transmission seal on older Jeep rear-drive setups.

What This Seal Helps Address

• Transmission fluid seepage at the rear seal area
• Contamination entering the transmission through a worn seal
• Leak-related low fluid condition during service intervals
• Seal wear from age, heat, and driveline use
• Fitment issues when replacing an incorrect rear transmission seal

Installation Notes and Tips

• Verify shaft diameter, outside diameter, and width before installation.
• Confirm rear-position fitment and transmission configuration for your Jeep.
• Inspect the shaft and sealing surface for scoring or wear before installing the new seal.
• Clean the bore and surrounding area so the seal seats evenly.
• Use the vehicle’s service procedure for proper seal installation depth and orientation.

Quality Assurance

SKF designs and manufactures seals to high quality standards using materials selected for the application and operating environment. The brand’s seal engineering background supports long service life and dependable sealing performance in automotive use.