SKF 19333 Wheel Seal - Rear Outer

SKF 19333 Wheel Seal for Driveline Service

SKF 19333 is a wheel seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. It uses a nitrile sealing surface and precise dimensions to support a proper seal at the shaft and hub interface.

• Wheel seal for driveline and axle sealing systems
• Nitrile sealing surface for dependable contact performance
• Outside diameter: 3.945 in.
• Shaft diameter: 1.930 in.
• Width: 0.315 in.
• SKF part number 19333 for direct catalog identification

Seal Design and Dimensions

This SKF wheel seal is engineered around exact dimensional requirements: 3.945-inch outside diameter, 1.930-inch shaft diameter, and 0.315-inch width. Those measurements matter when replacing a worn axle or wheel seal because the correct fit helps maintain lubricant inside the assembly and keeps road debris, water, and dust out. SKF 19333 is built with a nitrile sealing surface, a material commonly used in automotive sealing applications for its balance of flexibility and resistance in service.

SKF has a long history in seal engineering, and this part reflects that focus on controlled design and material selection. For vehicle owners searching for SKF 19333 wheel seal, axle seal replacement, or driveline sealing components for Honda Civic and similar applications, the key is matching the seal dimensions and application requirements exactly.

This part cross-references 8-94101493-0 and 94101493 for the same application.

What This Wheel Seal Helps Address

• Gear oil or lubricant seepage at the wheel end
• Contamination entering the axle or hub area
• Seal wear from age, heat, and road exposure
• Noise or rough operation caused by compromised lubrication retention
• Replacement needs during driveline or axle service

Installation Notes and Tips

Verify the shaft diameter, outside diameter, and width before installation to confirm the seal matches the hub or axle bore. Inspect the sealing surface and mating components for scoring, corrosion, or debris before pressing the seal into place. Clean the area thoroughly and follow the vehicle service procedure for the correct installation depth and orientation. For Honda Civic wheel seal replacement searches and other make/model-specific axle service jobs, accurate measurement is essential.

Quality Assurance

SKF designs and manufactures seals to controlled quality standards using premium materials selected for the application and operating environment. The brand’s seal engineering heritage includes decades of development focused on keeping lubricants in and contaminants out. SKF 19333 is built to support long service life and safe operation when installed on the correct application.