SKF 21135 Differential Pinion Seal - Rear

SKF 21135 Differential Pinion Seal for Camaro

SKF 21135 is a differential pinion seal built for rear axle sealing performance on select 2010-2015 Chevrolet Camaro applications. It is specified with a 2.125 shaft diameter, 2.922 outside diameter, and 0.500 width, with a LongLife sealing surface type for consistent sealing at the pinion area.

Key Features

• Part number 21135 differential pinion seal from SKF
• Fits 2010-2015 Chevrolet Camaro, rear
• 2.125 shaft diameter for the pinion interface
• 2.922 outside diameter and 0.500 width
• LongLife sealing surface type for durable sealing contact
• Cross-reference: Monroe Shocks & Struts 40053191

Detailed Description

SKF 21135 is engineered for rear differential pinion sealing where lubricant retention and contamination control are critical. SKF has a long history in seal design and uses premium materials and application-specific construction to match the demands of the operating environment. For Chevrolet Camaro rear differential service, this seal helps maintain proper sealing at the pinion shaft area while supporting long-term driveline reliability. If you are servicing a 2010-2015 Chevrolet Camaro rear differential, SKF 21135 provides the correct dimensional fit for the application.

What It Helps Address

• Rear differential gear oil seepage at the pinion seal
• Contamination entering the differential housing
• Loss of lubricant from worn or damaged seal surfaces
• Noise or driveline concerns related to low fluid level
• Service replacement for a leaking Chevrolet Camaro rear pinion seal

Installation Notes and Tips

Verify shaft diameter, outside diameter, and seal width before installation. Inspect the pinion yoke and sealing surface for wear, scoring, or corrosion, since surface condition affects seal life. Clean the housing bore thoroughly and install the seal squarely to avoid distortion. Confirm proper differential fluid level after service. Fits 2010-2015 Chevrolet Camaro, rear.

Quality Assurance

SKF manufactures seals to defined design and material standards for application-specific performance. The LongLife sealing surface type is intended to support durable sealing contact in driveline service. Part number 21135 is built to SKF’s established seal engineering practices for rear differential use.