SKF 22130 Transfer Case Power Take Off (PTO) Shaft Seal - Rear

SKF Transfer Case PTO Shaft Seal 22130

SKF 22130 is a transfer case power take off (PTO) shaft seal built for controlled sealing at the shaft interface. With a polyacrylate sealing surface, 2.219 shaft diameter, 2.714 outside diameter, and 0.252 width, it is specified for applications that need accurate fit and stable sealing performance in the transfer case assembly.

Key Features

• Transfer case PTO shaft seal for sealing the power take off shaft area
• Polyacrylate sealing surface type for the intended sealing environment
• 2.219 shaft diameter for application-specific fitment
• 2.714 outside diameter and 0.252 width for dimensional accuracy
• SKF engineered seal design backed by long-running sealing expertise

Application Details

This SKF transfer case seal is listed for 2008-2009 Ford Taurus X, rear, as well as 2001-2006 Ford Escape, outer left, and 2005-2006 Mercury Mariner, outer left. If you are sourcing a Ford Escape transfer case PTO shaft seal or a Mercury Mariner outer left seal, part number 22130 is the direct reference to verify against your original component. This part cross-references Ford 3L8ZH469AA for the same application.

SKF designs and manufactures seals using application-specific materials so the seal properties match the operating environment. That approach matters in transfer case service, where the seal must retain lubricant and keep road contaminants out while maintaining consistent contact at the shaft.

Common Problems This Seal Addresses

• Transfer case fluid leakage at the PTO shaft
• Contamination entering the sealed shaft area
• Wear-related seepage around the shaft interface
• Incorrect seal dimensions during transfer case repair
• Noise or drivability concerns linked to low lubricant level

Installation Notes and Tips

Confirm the shaft diameter, outside diameter, and width against the removed seal before installation. Clean the bore and shaft surface thoroughly, inspect for scoring or corrosion, and verify the seal orientation before pressing it into place. For Ford Taurus X, Ford Escape, and Mercury Mariner applications, match the vehicle position and notes exactly to the catalog listing before final assembly.

Quality Assurance

SKF has a long history in shaft seal development and uses premium materials with precise manufacturing standards for sealing applications. Part number 22130 is produced to support long service life and dependable sealing performance in the correct transfer case application.