SKF 22284 Wheel Seal - Rear Outer

SKF 22284 Wheel Seal Overview

SKF 22284 is a wheel seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. It uses a nitrile sealing surface and precise dimensions to support a proper seal at the shaft and hub interface.

For buyers searching for a wheel seal for Honda Civic, Toyota Corolla, or similar passenger vehicle applications, SKF 22284 provides a dimension-specific replacement option. The SKF 22284 wheel seal is engineered to match the application’s sealing requirements and operating environment.

Key Features

• Part number: 22284
• Outside diameter: 4.823
• Shaft diameter: 2.244
• Width: 0.413
• Nitrile sealing surface type for sealing performance in axle and wheel-end service
• SKF seal design and manufacturing standards focused on long service life and safety

Detailed Description

SKF has a long history in seal engineering, and the 22284 wheel seal reflects that experience with a design centered on fit, material selection, and sealing consistency. The nitrile sealing surface is selected for use in environments where the seal must help keep lubricants in place while limiting the entry of dirt, water, and road contaminants. If you are replacing a worn wheel seal on a Honda Civic, Toyota Corolla, or another vehicle using this size specification, SKF 22284 offers a direct dimensional match to verify before installation. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What This Wheel Seal Helps Address

• Gear oil or lubricant seepage at the wheel-end seal area
• Contamination entering the axle or hub assembly
• Seal wear from age, heat, and road exposure
• Noisy or rough operation caused by compromised sealing surfaces
• Maintenance needs tied to wheel-end service on vehicles such as Honda Civic and Toyota Corolla

Installation Notes and Tips

Confirm shaft diameter, outside diameter, and width against the original seal before installation. Inspect the sealing surface and mating components for scoring, corrosion, or debris, and replace damaged hardware or worn mating parts as needed. Clean the sealing area thoroughly so the nitrile lip can seat correctly and maintain consistent contact.

Quality Assurance

SKF designs and manufactures seals to specific application requirements using premium materials and established sealing technology. The brand’s seal engineering background supports consistent fit and dependable sealing performance in driveline and axle service. Part number 22284 should always be matched to the vehicle’s required dimensions and service application before use.