SKF 22808 Wheel Seal - Rear

SKF 22808 Rear Wheel Seal for Infiniti

SKF 22808 is a rear wheel seal built for specific Infiniti applications, including Q45 and J30 models. It is engineered with a nitrile sealing surface to help maintain a reliable barrier at the wheel end, where heat, road splash, and contamination can affect service life.

• Rear wheel seal for select Infiniti applications
• Nitrile sealing surface for dependable sealing performance
• Outside diameter: 2.879
• Shaft diameter: 2.283
• Width: 0.507
• SKF part number 22808 for direct identification

Application Details

Compatible with 2002-2003 Infiniti Q45, rear; 1997-2001 Infiniti Q45, rear, w/o Full Active Suspension; and 1993-1997 Infiniti J30, rear. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

How It Helps

• Stops gear oil or lubricant seepage at the wheel end
• Helps keep dirt, water, and debris out of the sealed area
• Addresses noise or wear caused by a compromised seal
• Supports proper wheel-end lubrication retention on Infiniti Q45 and J30 rear applications

Installation Notes

Verify shaft diameter, outside diameter, and width before installation to confirm the seal matches the hub or axle housing. Clean the sealing surface thoroughly and inspect the mating components for grooves, corrosion, or damage that could affect sealing performance. Confirm vehicle configuration on 1997-2001 Infiniti Q45 models, since this application excludes Full Active Suspension.

Quality Assurance

SKF has a long history in seal engineering and uses application-specific designs with premium materials to match operating conditions. SKF 22808 is manufactured to support long service life and consistent sealing performance in demanding driveline environments.