SKF 24897 Manual Transmission Seal - Rear

SKF 24897 Manual Transmission Seal

SKF 24897 is a manual transmission seal built for applications that need a precise sealing surface and stable fit around a 2.500-inch shaft diameter. With a 3.256-inch outside diameter and 0.375-inch width, this seal is sized for controlled retention of transmission lubricant while helping keep road contaminants out.

For buyers searching for a manual transmission seal for SKF 24897, or a transmission seal for specific make/model service work, this part is engineered with a nitrile sealing surface for dependable contact in demanding drivetrain environments. It is a practical choice for manual transmission repair on vehicles such as Ford F-150 and Chevrolet Silverado service applications where seal integrity matters.

Key Features

• Manual transmission seal from SKF
• Part number: 24897
• 0.375-inch width for compact sealing applications
• 3.256-inch outside diameter
• 2.500-inch shaft diameter specification
• Nitrile sealing surface type
• Built for lubricant retention and contaminant exclusion

Detailed Description

SKF has a long history in seal engineering, including early integrated shaft seal development and continued refinement of bonding methods and material selection. SKF 24897 reflects that approach with a seal design made to specific dimensions and premium materials chosen for the operating environment. The nitrile sealing surface is selected for consistent sealing performance in transmission service, where heat, motion, and fluid exposure place steady demands on the component.

This manual transmission seal is a direct-fit style service part for repair work where the original seal has hardened, worn, or begun leaking. It is also a strong search match for long-tail automotive queries such as manual transmission seal for Ford F-150, transmission output seal for Chevrolet Silverado, and SKF 24897 seal replacement.

This part cross-references Dayco 72893 for the same application.

Common Problems This Seal Can Address

• Transmission fluid leaking from the seal area
• Contamination entering the transmission housing
• Seal wear from age, heat, or shaft movement
• Loss of lubricant retention at the shaft interface
• Service replacement during manual transmission repair

Installation Notes and Tips

Inspect the shaft surface, bore, and surrounding housing before installation. Clean the sealing area thoroughly, verify the 2.500-inch shaft diameter and 3.256-inch outside diameter against the original part, and replace any worn mating components that could damage the new seal. Proper alignment during installation helps prevent premature wear and leakage.

Compatible With manual transmission service on Ford F-150 and Chevrolet Silverado applications where the listed dimensions match the original seal specification. SKF 24897 should be installed only after confirming the application dimensions and seal profile.

Quality Assurance

SKF designs and manufactures seals to high quality standards with an emphasis on long service life and safety. The brand’s seal engineering heritage and material control support consistent performance in drivetrain sealing applications.