SKF 25009 Wheel Seal - Front

SKF 25009 Wheel Seal for Ford Front Axles

SKF 25009 is a front wheel seal built for specific Ford Bronco and Ford F-150 applications. It uses a nitrile sealing surface and precise dimensions to help maintain proper sealing at the wheel end, keeping lubricant contained and road contaminants out.

Key Features

• Wheel seal for front axle applications
• Nitrile sealing surface for dependable sealing performance
• Outside diameter: 3.228 in.
• Shaft diameter: 2.500 in.
• Width: 0.728 in.
• Engineered by SKF, a long-established seal manufacturer

Product Details

SKF 25009 is designed for front wheel-end sealing on 1995-1996 Ford Bronco and 1995-1996 Ford F-150 applications listed below. The seal dimensions and nitrile sealing surface are specified to match the intended axle interface and help support proper lubrication retention at the hub area. If you are replacing a worn front wheel seal on a Ford Bronco or Ford F-150, SKF 25009 provides a direct-fit service part for the listed configurations. This part cross-references Ford F5TZ1175A for the same application.

Common Problems This Part Can Address

• Gear oil or lubricant leakage at the front wheel end
• Contamination entering the hub or axle seal area
• Seal wear from age, heat, or road exposure
• Noise or service issues related to compromised wheel-end sealing
• Maintenance replacement during front hub or axle service

Installation Notes and Tips

• Verify axle and hub dimensions before installation, including the 2.500 in. shaft diameter and 3.228 in. outside diameter.
• Inspect the sealing surface and surrounding components for scoring, corrosion, or debris before fitting the new seal.
• Confirm the vehicle configuration: 1996 Ford Bronco front with boot and manual locking hubs; 1995-1996 Ford Bronco front with boot and automatic locking hubs; 1996 Ford F-150 front with boot; 1995 Ford Bronco front with boot, manual locking hubs, from 5/1/95; 1995 Ford F-150 front with boot, from 5/1/95.
• Use clean assembly practices to avoid damaging the nitrile sealing lip during installation.

Quality Assurance

SKF has a long history in seal engineering and manufactures sealing products to defined design and material standards. SKF 25009 is built for the listed Ford Bronco and Ford F-150 front applications, with dimensions and sealing material selected for proper fit and service life.