SKF 26368 Wheel Seal - Rear

SKF 26368 Wheel Seal for Driveline Service

SKF 26368 is a wheel seal built for driveline and axle sealing applications where lubricant retention and contamination control matter. With a 2.625 inside diameter, 4.443 outside diameter, and 0.438 width, it is sized for precise sealing performance in the hub area.

For drivers searching for a wheel seal for Honda Civic or Toyota Corolla service, SKF 26368 provides a nitrile sealing surface and SKF engineering focused on consistent fit and long service life.

Key Features

• Part number: 26368
• Inside diameter: 2.625 in.
• Outside diameter: 4.443 in.
• Width: 0.438 in.
• Nitrile sealing surface type for sealing performance in demanding driveline environments
• Shaft diameter: 2.625 in.
• Cross-reference: Monroe Shocks & Struts (e.g., 36579HA) for the same application

Detailed Description

SKF 26368 is a wheel seal designed for axle and hub sealing where the seal must keep lubricants in place and help block road debris, water, and other contaminants. SKF has a long history in seal design and manufacturing, and this part reflects that experience with application-specific dimensions and premium sealing materials. The nitrile sealing surface supports reliable contact at the shaft interface, while the listed dimensions help confirm proper sizing before installation.

This wheel seal is a practical choice for driveline and axle maintenance on vehicles such as Honda Civic and Toyota Corolla when the application calls for SKF 26368. Use the part number 26368 to verify the correct seal against the original component or service catalog.

What This Wheel Seal Helps Address

• Gear oil or lubricant leakage at the wheel end
• Contamination entering the hub or axle area
• Seal wear from age, heat, and road exposure
• Noise or rough operation caused by compromised sealing
• Service issues tied to incorrect seal dimensions

Installation Notes and Tips

Confirm inside diameter, outside diameter, width, and shaft diameter before installation. Inspect the shaft and sealing surface for scoring, corrosion, or debris, and replace any damaged mating components as needed. Clean the bore and seating area thoroughly so the seal installs squarely and seats fully. Verify the application by part number 26368 and compare it with the original seal dimensions before assembly.

Quality Assurance

SKF designs and manufactures seals to specific application requirements using premium materials and established sealing technology. The brand’s seal engineering heritage dates back to the first integrated shaft seal in 1928, and SKF products are built to meet high manufacturing standards for durability and safety.